Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

System ManagementParameterDescriptionProduct DescriptionNumber of RadiosNumber of EthernetInterfacesRadio 1 AllowedFrequency BandMaximum OutputBandwidthMaximum InputBandwidthMaximum AggregateBandwidthProduct FamilyProduct ClassAllowed OperationalModes of Radio1MAC Address of thedevice isSpecifies the product description.Specifies the number of radios that the device is licensed to operate.Specifies the number of Ethernet interfaces that the device is licensed to operate.Specifies the wireless operational frequency band supported by the device.Specifies the Maximum output bandwidth limit in multiples of 1Mbps (Refer to Notebelow).Specifies the Maximum input bandwidth limit in multiples of 1Mbps (Refer to Note below).Specifies the Max cumulative bandwidth of the device which is the sum of configuredoutput and input.Specifies the Product Family of the device.Specifies the Product Class of the device. It can be indoor or outdoor product based on thisparameter.Specifies the device operational mode as End Point A/End Point B.Specifies the MAC address of the device.NOTE: The Input and Output Bandwidth features are referred with respect to the wireless interface. That is, inputbandwidth refers to the data received on the wireless interface and output bandwidth refers to the data sentout of the wireless interface.5.2 File ManagementUsing this section, you can upgrade the firmware or configuration of the device and also retrieve the log/configuration filesfrom the device. File Management can be done using TFTP (by using an external TFTP Server) using Web, CLI or SNMP. It canalso be done using the HTTP using Web Interface.5.2.1 Upgrade Firmware via HTTPFor upgrading the firmware via HTTP web interface, click MANAGEMENT > File Management > Upgrade Firmware > HTTP.Tsunami QB-8100 Series (50 Mbps / 12 Mbps) Installation and Management Guide 113