Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

Advanced ConfigurationFigure 4-6 WORP Configuration2. Enter the appropriate parameters in the WORP Configuration screen. Refer to the following table for the descriptionsof the parameters.3. Click OK.ParameterModeNetwork NameWORP MTUSuper FramingDescriptionSpecifies the radio mode in which the device is configured.It is the name given to a network so that an End Point A and an End Point B can mutuallyauthenticate. End Point B can register to End Point A only if it has the same Network Name.The Network Name can be 1 to 32 characters in length.WORP MTU (Maximum Transfer Unit) is the largest size of the data payload in wirelessframe that may be transmitted. The MTU size can range from 350 to 3808 for HighThroughput modes.The default and maximum value of the WORP MTU is 3808.Super Framing refers to the mechanism that enables multiple Ethernet/802.3 frames to bepacked in a single WORP data frame. When the WORP MTU size is configured larger thanthe Ethernet frame size, then WORP constructs a super frame with size of the WORP MTUconfigured and pack multiple Ethernet frames. It results in reducing the number of framestransmitted over wireless medium thereby conserving wireless medium and increasing theoverall throughput.Tsunami QB-8100 Series (50 Mbps / 12 Mbps) Installation and Management Guide 42