Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)
Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)
Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Advanced ConfigurationParameterMaximum MTUDescriptionThis feature provides support for Ethernet frames with more than 1,<strong>50</strong>0 bytes of payload(MTU). It can be configured with any value between 1<strong>50</strong>0 to 2048 bytes. By default, itsvalue is 1<strong>50</strong>0.NOTES:• The “Max MTU” configured does not include Ethernet Header (14 bytes) andVLAN tag (4 bytes).• For optimal performance, same value of MTU should be configured on bothEnd Point A and End Point B.NOTE: Click COMMIT and REBOOT after changing any system parameters.4.2 Network ConfigurationBased on the selected mode of operation, the IP settings vary. When the device is in Bridge mode, only a single IP address isrequired; but for Routing mode, individual IP address are needed for each of the Ethernet and Wireless interfaces. In Bridgemode, the IP address can be statically assigned or dynamically obtained through DHCP; whereas in Routing mode, only staticassignment is supported.4.2.1 Configuring IP in Bridge or Router ModeTo view the network settings,1. Click ADVANCED CONFIGURATION > Network.If the device is configured in Bridge mode, the following screen appears:Figure 4-2 IP Configuration in Bridge ModeIf the device is configured in Router mode, the following screen appears:Figure 4-3 IP configuration in Router modeTo configure the Network IP properties,1. Click ADVANCED CONFIGURATION > Network > IP Configuration. The following screen appears:Tsunami <strong>QB</strong>-<strong>8100</strong> <strong>Series</strong> (<strong>50</strong> <strong>Mbps</strong> / <strong>12</strong> <strong>Mbps</strong>) Installation and Management Guide 38
Change language