Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

Advanced Configurationb. Specify the QoS Class Name, Service Flow Name PIR Rule Name Priority and Entry Status and click Add.ParameterClass NameService Flow NamePIR Rule NamePriorityEntry StatusDescriptionSpecifies the Name of the QoS Class. This name length can range from 1 to 32 characters.Specifies the Service Flow to be associated with the QoS Class. Select one of the possibleSFCs that have been previously configured in the SFC List.Specifies the PIR Rule need to be associated with this Service Flow. Select one of thepossible PIRs that have been previously configured in the PIR List.Specifies priority or order of execution of PIRs during packet identification process. The PIRpriority is a number that can range from 0-63, with priority 63 being executed first, andpriority 0 being executed last. The PIR priority is defined within a QoS class, and can bedifferent for the same PIR in some other QoS class. If all PIRs within one QoS class have thesame priority, the order of execution of PIR rules will be defined by the order of definitionof SFCs, and by the order of definition of PIRs in each SFC, within that QoS class.Specifies the status of the QoS Class as enable/disable.Adding Service Flows in QoS Class1. Click on the corresponding Details of the QoS Class for adding more Service Flows. Each QoS Class can havemaximum 8 Service Flows. At least there should be one service flow per QoS Class. The following screen is displayedto configure the new SFC entry inside the QoS Class.Figure 4-39 QoS Class Service Flow Details2. Click Add. The following screen appears for association of the new SFC in this QoS Class.Tsunami QB-8100 Series (50 Mbps / 12 Mbps) Installation and Management Guide 77