Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

System ManagementRead PasswordRead/Write PasswordThis parameter represents the read only community name used in SNMP Protocol. It is sentalong with each SNMP GET / WALK / GETNEXT / GETBULK request to allow or deny accessto the device. This password should be same as read password set at the NMS or MIBbrowser. The default password is “public” and range of this parameter must be between6-32 characters.This parameter represents the read-write community name used in SNMP Protocol. It issent along with each SNMP GET / WALK / GETNEXT / SET request to allow or deny access tothe device. This password should be same as read-write password set at the NMS or MIBbrowser. The default password is “public” and range of this parameter must be between6-32 characters.5.3.3.1 SNMPv3 ConfigurationFigure 5-14 SNMPv3On selecting SNMP V3, the following parameters need to be configured:SNMP V3 Parameter settingsSecurity levelThe supported security levels for QB-8100 is AuthNoPriv and AuthPriv. SelectAuthNoPriv for Extensible Authentication or AuthPriv for both Authentication andPrivacy (Encryption).Tsunami QB-8100 Series (50 Mbps / 12 Mbps) Installation and Management Guide 121