Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

ProceduresFigure 7-7 Update the device with TBC File via TFTP1. Select the Text Based Config option button.2. Enter the TFTP Server IP Address.3. Enter the name of the configuration file to be updated to the device.• Click Update to initiate the TFTP update operation. Then click Load to apply the updated changes. Finally clickCOMMIT for the changes to take effect.Or• Click Update & Load to update and load with new configurations, the following window appears.Figure 7-8 Message Window after successful loading of TBC File• Click COMMIT for the changes to take effect.7.5.6 Loading the TBC fileAll configurations in the TBC file can be loaded to the device using all the three interfaces (SNMP/WEB/ CLI). The Update,Load and Update & Load tabs present in the MANAGEMENT > File Management > Upgrade Configuration page areused to load the TBC file using WEB. To load the TBC file, it should be generated or downloaded to the device.If the TBC file is not with correct XML syntax, the file will be discarded with DOM error and no configurations will be loaded.All duplicate values entered are considered as errors while loading and syslog will be generated accordingly. Therefore, it isrecommended to delete all unchanged parameters from the TBC file during its edition. Commit is required to retain theconfigurations across reboots after loading the TBC file.NOTE: Both Commit and Reboot are required to accept the modifications done in the TBC File. Only reboot is requiredto reject the modifications.Loading the TBC file is allowed only once in an active device session (i.e., if TBC file is loaded, reboot is required to apply allconfigurations or to load another TBC file). All configurations in the TBC file are loaded to the device irrespective of theirTsunami QB-8100 Series (50 Mbps / 12 Mbps) Installation and Management Guide 155