Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

Advanced ConfigurationFigure 4-4 IP Configuration1. Enter the appropriate parameters in the IP Configuration screen. See the following table that lists and describes theparameters.2. Click OK. The IP configuration takes effect only after Reboot.ParameterDescriptionEthernetAddress TypeIP AddressSubnet MaskThis field is applicable only if the Network mode on the System screen is configured inBridge mode. This parameter specifies whether the device network parameters are to beconfigured through DHCP or to be assigned statically.Select Dynamic to configure the device as a Dynamic Host Configuration Protocol (DHCP)client. If Dynamic is selected, the device obtains the IP settings from a network DHCPserver automatically during the bootup. If you do not have a DHCP server or if you want tomanually configure the device’s IP settings, select Static for the Address Type.Enter the IP Address of the interface.In Bridge Mode: When the Address Type is selected as Dynamic, this field becomesread-only and displays the current IP address of the device.If the device cannot obtain an address from a DHCP server, it displays the default IPAddress as 169.254.128.132 for End Point A and 169.254.128.131 for End Point B.In Routing Mode: For these interfaces, this field displays the default IP Addresses asfollows:Ethernet interface: 169.254.128.132Wireless interface: 169.254.130.132This parameter represents the subnet mask of the interface.In Bridge Mode: When the Address Type is selected as Dynamic, this field becomesread-only and displays the current subnet mask of the device.If the device cannot obtain an address from a DHCP server, it displays the default subnetmask as 255.255.255.0.Tsunami QB-8100 Series (50 Mbps / 12 Mbps) Installation and Management Guide 39