Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

More documents

Recommendations

Info

Monitoring the SystemFieldSend FailuresReceive SuccessReceive RetriesReceive FailuresRegistration detailsRemote PartnersAnnouncementsRequest For ServiceRegistration RequestsRegistration RejectsAuthenticationRequestsAuthenticationConfirmsRegistration AttemptsRegistrationIncompletesRegistration TimeoutsRegistration LastReasonDescriptionRefers to the number of data messages that requires re-transmission. These frames are notacknowledged by the peer.Refers to the number of data messages received and acknowledged successfully.Refers to the number of successfully received re-transmitted data messages.Refers to the number of data messages that were not received successfully.Specifies the status of the entire registration process.Refers to the number of remote partners. For an End Point B, this parameter is always zeroor one.Refers to the number of Announcement messages sent (End Point A) or received (End PointB) on WORP interface.Refers to the number of requests for service messages sent (End Point B) or received (EndPoint A).Refers to the number of registration request messages sent (End Point B) or received (EndPoint A) on WORP interface.Refers to the number of registration reject messages sent (End Point A) or received (EndPoint B) on WORP interface.Refers to the number of authentication request messages sent (End Point B) or received(End Point A) on WORP interface.Refers to the number of authentication confirm messages sent (End Point A) or received(End Point B) on WORP interface.Refers to the number of times a Registration Attempt has been initiated.Refers to the number of registration attempts that is not completed yet.Refers to the number of times the registration procedure timed out.Refers to the reason for why the last registration was aborted or failed.NOTE: For better results, the Send Failure/Send Retrieve must be low in comparison to Send Success. The same appliesfor Receive Retries/Receive Failure. Click Refresh to update the details in this page.6.2.2 End Point B Link Statistics (End Point A only)WORP End Point B Link Statistics provides the information related to the End Point B currently connected to the End Point A.This operation is available only in End Point A mode operations.To view the Interface Statistics, click MONITOR > WORP Statistics > Interface 1 > End Point B Link Statistics.Tsunami QB-8100 Series (50 Mbps / 12 Mbps) Installation and Management Guide 132
Monitoring the SystemFigure 6-4 End Point B Link StatisticsClick Refresh, to get the updated or latest End Point B Link Statistics.To view detailed interface Statistics, click Details in the End Point B Link Statistics screen. The following screen appears:The following table lists the parameters and their descriptions:FieldEnd Point B NameMac AddressLocal Tx Rate (Mbps)DescriptionSystem name of the End Point B connected.MAC address of the End Point B connected.End Point A Tx Rate.Tsunami QB-8100 Series (50 Mbps / 12 Mbps) Installation and Management Guide 133
Page 1:
Tsunami QB-8100 Series (50 Mbps / 1
Page 6 and 7:
Event Log . . . . . . . . . . . . .
Page 8 and 9:
PrefacePrefaceAbout this ManualCong
Page 10 and 11:
Overview1.1 IntroductionProxim’s
Page 12 and 13:
OverviewNetwork Manager program usi
Page 14 and 15:
Installation and Initialization2.1.
Page 16 and 17:
Installation and InitializationWhat
Page 18 and 19:
Installation and Initialization2. M
Page 20 and 21:
Installation and InitializationFigu
Page 22 and 23:
Installation and InitializationUsin
Page 24 and 25:
Installation and InitializationThe
Page 26 and 27:
Installation and InitializationFigu
Page 28 and 29:
Basic Configuration3This chapter co
Page 30 and 31:
Basic ConfigurationIf ACS is disabl
Page 32 and 33:
Basic Configuration3.7 Basic Config
Page 34 and 35:
Basic ConfigurationPreferred Channe
Page 36 and 37:
Advanced Configuration4This chapter
Page 38 and 39:
Advanced ConfigurationParameterMaxi
Page 40 and 41:
Advanced ConfigurationParameterDesc
Page 42 and 43:
Advanced ConfigurationFigure 4-6 WO
Page 44 and 45:
Advanced ConfigurationParameterMAC
Page 46 and 47:
Advanced ConfigurationParameterSate
Page 48 and 49:
Advanced Configuration4.4.6 MIMO Pr
Page 50 and 51:
Advanced ConfigurationIf ACS is dis
Page 52 and 53:
Advanced Configuration4.4.7.3 Black
Page 54 and 55:
Advanced ConfigurationMaximum RateT
Page 56 and 57:
Advanced ConfigurationFigure 4-13 W
Page 58 and 59:
Advanced Configuration1. Click ADVA
Page 60 and 61:
Advanced ConfigurationNOTE: Based o
Page 62 and 63:
Advanced Configurationa. Ether Type
Page 64 and 65:
Advanced Configuration• Service F
Page 66 and 67:
Advanced ConfigurationFigure 4-21 Q
Page 68 and 69:
Page 70 and 71:
Advanced ConfigurationParameterRule
Page 72 and 73:
Page 74 and 75:
Page 76 and 77:
Advanced Configuration4.6.2.3 QoS C
Page 78 and 79:
Page 80 and 81:
Advanced Configuration4.6.3 QoS Con
Page 82 and 83: Advanced Configuration• Traffic D
Page 84 and 85: Advanced ConfigurationVLAN paramete
Page 86 and 87: Advanced ConfigurationAdding New Tr
Page 88 and 89: Advanced ConfigurationFigure 4-50 F
Page 90 and 91: Advanced ConfigurationParameterDesc
Page 92 and 93: Advanced ConfigurationResult: When
Page 94 and 95: Advanced ConfigurationFigure 4-55 A
Page 96 and 97: Advanced ConfigurationFigure 4-57 T
Page 98 and 99: Advanced ConfigurationParameterInte
Page 100 and 101: Advanced ConfigurationCommentParame
Page 102 and 103: Advanced ConfigurationFigure 4-65 D
Page 104 and 105: Advanced Configuration2. Enter the
Page 106 and 107: Advanced Configuration1. Static NAT
Page 108 and 109: Advanced ConfigurationS.No. Protoco
Page 110 and 111: System Management5This chapter prov
Page 112 and 113: System Management5.1.2 Identifying
Page 114 and 115: System ManagementFigure 5-4 HTTP Up
Page 116 and 117: System ManagementFigure 5-7 Upgrade
Page 118 and 119: System Management3. Select the type
Page 120 and 121: System ManagementSSH PortSSH Sessio
Page 122 and 123: System ManagementPriv ProtocolPriv
Page 124 and 125: System ManagementParameterDescripti
Page 126 and 127: System ManagementFigure 5-20 Manage
Page 128 and 129: Monitoring the System6.1 Interface
Page 130 and 131: Monitoring the SystemParameterCRC E
Page 134 and 135: Monitoring the SystemFieldDescripti
Page 136 and 137: Monitoring the System6.3 Bridge6.3.
Page 138 and 139: Monitoring the System6.4 Network La
Page 140 and 141: Monitoring the SystemFieldIn Timest
Page 142 and 143: Monitoring the System6.6 IGMP (Brid
Page 144 and 145: Monitoring the SystemFigure 6-17 Ev
Page 146 and 147: Monitoring the SystemFigure 6-20 WO
Page 148 and 149: Procedures7This chapter provides de
Page 150 and 151: Procedures7.3 Configuration BackupY
Page 152 and 153: ProceduresFigure 7-1 HTTP Retrieve
Page 154 and 155: Procedures• Remove unchanged conf
Page 156 and 157: Proceduresdefault or modified or ad
Page 158 and 159: Troubleshooting8.1 PoE Injector8.1.
Page 160 and 161: Troubleshooting4. If you are using
Page 162 and 163: TroubleshootingSystem Name(config-n
Page 164 and 165: Troubleshooting8.4.8 Changes Do Not
Page 166 and 167: Frequency Domains and ChannelsAIntr
Page 168 and 169: Frequency Domains and Channels5 GHz
Page 170 and 171: Frequency Domains and ChannelsFrequ
Page 172 and 173: Boot Loader CLI and ScanToolTo Load
Page 174 and 175: Technical SpecificationsPart Number
Page 176 and 177: Technical SpecificationsIntegrated
Page 178 and 179: Technical SpecificationsTransmit Po
Page 180 and 181: Technical SpecificationsCategorySpe
Page 182 and 183:
Technical SpecificationsPhysical an
Page 184 and 185:
Parameters Requiring RebootETabulat
Page 186 and 187:
Statement of WarrantyFWarranty Cove
Page 188 and 189:
Technical Services and SupportGObta
Page 190:
Technical Services and SupportServP
show all

Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

Create successful ePaper yourself

Delete template?

Save as template?