CMOS Optical Preamplifier Design Using Graphical Circuit Analysis

electronics, vol. 147, no. 1, pp. 2-6, February 2000.
1.2 Thesis Outline 8
J. F. Duque-Carrillo, J. L. Ausin, G. Torelli, J. M. Valverde, and M. A. Dominguez, “1-V Rail-to-Rail
Operational Amplifiers in Standard CMOS Technology,” IEEE J. Solid-State Circuits, vol. 35,
no. 1, pp. 33-44, January 2000.
P. L. Eardley and D. R. Wisely, “1Gbit/s optical free space link operating over 40m — system and
applications,” IEE Proceedings on Optoelectronics, vol. 143, no. 6, pp. 330-333, December
1996.
D. W. Faulkner, D. B. Payne, J. R. Stern, and J. W. Ballance, “Optical networks for local loop applications,”
IEEE J. Lightwave Tech., vol. 7, no. 11, pp. 1741-1751, November 1989.
D. J. Frank, P. Solomon, S Reynolds, and J. Shin, "Supply and Threshold Voltage Optimization for
Low Power Design," IEEE Int. Symp. Low Power Electronics and Design, pp. 317-322, 1997.
M. Funada et al., “Proposal for a novel optical bus system using optical sheet bus technology,” Optoelectronic
Interconnects VI, J.P. Bristow and S. Tang, editors, Proc. SPIE, vol. 3632, San Jose,
CA, January 1999.
L. Geppert and T. S. Perry, “Transmeta’s magic show,” IEEE Spectrum, vol. 37, no. 5, pp. 26-33,
May 2000.
The Gigabit Ethernet Standard, IEEE Standard 802.3z, 1998.
D. J. T. Heatley, D. R. Wisely, I. Neild, and P. Cochrane, “Optical Wireless: The story so far,” IEEE
Commun. Mag., pp. 72-82, December 1998.
Infrared Data Association (IrDA), Serial Infrared Physical Layer Link Specification, Version 1.2,
http://www.irda.org, Nov. 1997
Infrared Data Association (IrDA), The IrDA Bulletin, http://www.irda.org, May-July 1999.
Jolt Ltd., Wireless Optical Communications, Web Site, http://www.jolt.co.il.
T. Kwok, “A vision for residential broadband services: ATM-to-the-home,” IEEE Network, vol. 9,
no. 5, pp. 14-28, Sept.-Oct. 1995.
Y. Li, E. Towe, and M. W. Henry, editors, “Special Issue on Optical Interconnections for Digital Systems,”
Proceedings of the IEEE, June 2000.
D. Liu and C. Svensson, “Trading Speed for Low Power by Choice of Supply and Threshold Voltages,”
IEEE J. Solid-State Circuits, vol. 28, no. 1, pp. 10-17, Jan. 1993.
M. Montrose, Printed Circuit Board Design Techniques for EMC Compliance, IEEE Press, New
York, 1996.
M. Nakamura and N. Ishihara, “1.2V, 35mW CMOS optical transceiver ICs for 50Mbit/s burst-mode
communication,” Electronic Letters, vol. 35, no. 5, pp. 394-395, 4 March 1999.
K. Ohhata, T. Masuda, K. Imai, R. Takeyari, and K. Washio, “A Wide-Dynamic Range, High-Transimpedance
Si Bipolar Preamplifier ICfor 10-Gb/s Optical Fiber Links,” IEEE J. Solid-State
Circuits, vol. 34, no. 1, pp. 18-24, January 1999.
C. Rooman, D. Coppee, and M. Kuijk, "Asynchronous 250Mb/s Optical Receivers with Integrated