TMPM330 - Keil

Under development
11.2.6 Receive Enable Register [CECREN]
TMPM330 (rev0.4)11-5
TMPM330
7 6 5 4 3 2 1 0
bit Symbol ― CECREN
Read/Write R R/W
After reset 0 0
Function
“0” is read. Receptio
n control
[Write]
0:
Disabled
1:
Enabled
[Read]
0:
Stopped
1: in
operation
: Controls the reception operation of CEC.
Writing “0” or “1” to this bit enables or disables data reception. This bit becomes ready
for data reception by writing “1”.
The state of the reception circuit is monitored by reading this bit. It enables you to
check if what you set has properly been reflected.
(Note 1) Enable the bit after setting the reception control register 1, 2 and 3.
(Note 2) It takes a little time to reflect the setting of the bit to the circuit. Stop
transmission and reception before changing the settings or enabling the
transmission and reception.
CEC