TMPM330 - Keil

Under development
TMPM330 (rev0.4)12-18
TMPM330
RMC keeps receiving 73 bit or more data unless reception is completed by detecting the maximum
data bit cycle or the excess low width. If so, the received data in the data buffer may not be correct.
To check the status of RMC after reception is completed, read the Remote Control Receive Status
Register. The status of RMC that each bit type indicates is shown below.
RMC Status
0 0000001~1001000 Receiving remote control signal without a leader (Data
bits: 1~72bit)
0 1001001~1111111 Receiving remote control signal without a leader (Data
bits: 73bit and more)
1 0000000 Only with a leader
1 0000001~1001000 Receiving remote control signal with a leader (Data bits:
1~72bit)
1 1001001~1111111 Receiving remote control signal without a leader (Data
bits: 73bit and more)
12.3.1.7 Stopping Reception
RMC stops reception by clearing the RMCREN bit to “0” (reception disabled).
Clearing this bit during reception stops reception immediately and the received data is discarded.
RMC