TMPM330 - Keil

Under development
Table 17-9 Transfer Format for the Show Product Information Command (2/2)
Byte Data Transferred from the Controller
to the TMPM330
TMPM330 (rev 0.4)17-22
TMPM330
Baud rate Data Transferred from the TMPM330
to the Controller
Boot ROM 61 byte -
- Size (in halfwords) of the same-size (16K)
64 byte
flash blocks (4 bytes)
00H, 20H, 00H and 00H from the 61 st byte
65 byte - Number of flash blocks of the same size
(1 byte) 02H
66 byte -
69 byte
- Start address of a group of the same-size
(32K) flash blocks (4 bytes)
00H, 00H, 80H and 3FH from 66 th byte
70 byte -
Size (in halfwords) of the same-size (32K)
73 byte
flash blocks (4 bytes)
00H, 40H, 00H and 00H from the 70 th
byte
74 byte Number of flash blocks of the same size
(32K) (1 byte) 02H
75 byte -
78 byte
Start address of a group of the same-size
(64K) flash blocks (4 bytes)
00H, 00H, 81H and 3FH from 75 th byte
79 byte -
Size (in halfwords) of the same-size (64K)
82 byte
flash blocks (4 bytes)
00H, 80H, 00H and 00H from the 79 th
byte
83 byte Number of flash blocks of the same size
(64K) (1 byte) 01H
84 byte -
87 byte
Start address of a group of the same-size
(128K) flash blocks (4 bytes)
00H, 00H, 01H and 00H from 84 th byte
88 byte -
Size (in halfwords) of the same-size (128K)
91 byte
flash blocks (4 bytes)
00H, 00H, 01H and 00H from the 88 th
byte
92 byte Number of flash blocks of the same size
(128K) (1 byte) 03H
93 byte Checksum value for bytes 5 - 92
94 byte (Wait for the next command code.) -
Note 1: In I/O Interface mode, the baud rate for the transfers of the first and second bytes must be
1/16 of the desired baud rate.
Note 2: In case of any negative acknowledge, the boot program returns to a state in which it waits
for a command code (3rd byte). In I/O Interface mode, if a communication error occurs, a
negative acknowledge does not occur.
Flash Memory Operation