TMPM330 - Keil

Under development
12.2.8 Remote Control Receive Control Register 2 [RMCRCR2]
bit Symbol
TMPM330 (rev0.4)12-8
TMPM330
31 30 29 28 27 26 25 24
RMCLIEN RMCEDIE
N
― ― ― ― RMCLD RMCPHM
Read/Write R/W R/W R R/W R/W
After reset 0 0 0 0 0
Function
Leader
detection
interrupt
0: Not
generated
1:
Generated
Remote
control
input
falling
edge
interrupt
0: Not
generated
1:
Generated
”0” is read. Receiving
remote
control
signal with
or without
leader
0:
Disabled
1:
Enabled
Receive a
remote
control
signal in
phase
method?
0: No
(receive in
cycle
method)
1:Yes
23 22 21 20 19 18 17 16
bit Symbol ― ― ― ― ― ― ― ―
Read/Write R
After reset 0
Function ”0” is read.
15 14 13 12 11 10 9 8
bit Symbol RMCLL7 RMCLL6 RMCLL5 RMCLL4 RMCLL3 RMCLL2 RMCLL1 RMCLL0
Read/Write R/W
After reset 1
Excess low width that triggers reception completion and interrupt generation
Function 00000000~11111110:RMCLL×1/fs[s]
11111111:not to use as the trigger
bit Symbol RMCDMA
X7
7 6 5 4 3 2 1 0
RMCDMA
X6
RMCDMA
X5
RMCDMA
X4
RMCDMA
X3
RMCDMA
X2
RMCDMA
X1
Read/Write R/W
After reset 1
Maximum data bit cycle that triggers reception completion and interrupt generation
Function 00000000~11111110:RMCDMAX×1/fs[s]
11111111: not to use as the trigger
: Enables to generate a leader detection interrupt by detecting a leader.
: Enables to generate a remote control input falling edge Interrupt.
: Enables RMC to receive signals with or without a leader.
RMCDMA
X0
: Specifies data reception mode of a phase method. If you use the phase method of
which signal cycle is fixed, set “1”.
: Specifies an excess low width. If an excess low width is detected, reception is
completed and an interrupt is generated. The low width is not detected if
= 11111111b. Calculating formula of an excess low width:
RMCLLx1/fs[s].
: Specifies a threshold for detecting a maximum data bit cycle. It is detected when a
data bit cycle exceeds the threshold. It is not detected when =
11111111b. Calculating formula of the threshold: RMCDMAX x 1/fs[s].
RMC