TMPM330 - Keil

(2) Settings of Detecting Leader
Under development
TMPM330 (rev0.4)12-14
TMPM330
To detect a leader, configure cycle and low width of the leader with the RMCRCR1
bits. When you configure
the register, you must follow the rule shown below.
Leader Rules
Low width + High width >
>
Only with high width >
>
= 0x00000000
= don’t care
No leader = 0x00000000
= don’t care
= don’t care
= don’t care
The following shows a leader waveform and the RMCRCR1 register settings.
Maximum cycle:
Minimum cycle:
Waiting for leader
Minimum low width:
Maximum low width:
Cycle
Low width
Leader detection interrupt
If you want to generate an interrupt when detecting a leader, configure the RMCRCR2
bit. A remote control signal without a leader cannot generate a leader detection interrupt.
RMC