TMPM330 - Keil

Under development
TMPM330 (rev 0.4)17-47
TMPM330
・When FLCS is other than "0 x 3F" (not all the protection bits are
programmed):
The protection condition can be canceled by the automatic protection bit erase operation.
With this device, protection bits set by an individual block can be erased handling all the
blocks at a time as shown in Table 17-22. The target bits are specified in the seventh bus
write cycle and when the command is completed, the device is in a condition all the blocks
are erased. The protection status of each block can be checked by FLCS to
be described later. This status of the programming operation for automatic protection bits
can be checked by monitoring FLCS . When the automatic operation to erase
protection bits is normally terminated, the protection bits of FLCS selected for
erasure are set to "0."
In any case, any new command sequence is not accepted while it is in an automatic
operation to erase protection bits. If it is desired to stop the operation, use the hardware
reset function. When the automatic operation to erase protection bits is normally terminated,
it returns to the read mode.
The FLCS bit is "0" while in automatic operation and it turns to "1" when the
automatic operation is terminated.
Flash Memory Operation