NAVFAC P-300 Management of Transportation Equipment

Block Entry
*9 Failed Part Replacement (FPR). Annotate it. For example, a
replacement pump failed (did not wear out).
10 Allowance Parts List/Allowance Equipage List/Component Identification
(APL/AEL/CID). Enter the APL number or TOA assembly number of the
equipment for which the item is requested.
11 Inventory. Supply entry.
12 Not In Stock/No Carried (NIS/NC). Supply entry.
13 Unit Identification Code (UIC). Prefix the UIC by the appropriate service
designator code: "R" for Pacific, "V" for Atlantic, and "N" for other units.
14 Work Center Code. Supply entry.
15 Job Sequence Number (JSN). The JSN is a four-digit numeric. When the
material being documented is not identified to a specific ERO, such as
Pre-Expended Bin (PEB), and SHOP USE material, the JSN block shall
be filled with zeros. When JSN "0000" is used, print "PEB" or "SHOP
USE," as applicable in Remarks Block 29. For maintenance and repair of
specific CESE items, each ERO shall be given a JSN sequentially
assigned between the numbers 0001 and 9999.
*16 Enter "Z100000" except for PEB or SHOP USE material, for which
"X000000" is entered.
17 Equipment COSAL Supported Yes/No. Supply entry.
18 Source Code. Supply entry.
19 Cognizance (COG). Enter the numeric-alpha cognizance symbol of the
NSN listed in Blocks 21 and 22.
21/23 National Stock Number/Navy Item Control Number (NSN/NICN); includes
Special Materials Identification Code (SMIC), if applicable. For part
number items, the Commercial and Government Entity (CAGE) must be
indicated, followed by the part number. When the manufacturer's part
number consists of ten digits or less, the part number shall begin in the
second position of Block 22 and may continue through Block 23. The
five-digit CAGE Code, if known, shall be entered in Block 21 and the first
position of Block 22. If the CAGE Code is not known and cannot be
5-13