NAVFAC P-300 Management of Transportation Equipment

. All FIRE TRUCKS (including wheels) shall be painted lime yellow (No.
13670) with a white reflective horizontal band of wide-angle prismatic reflective material
conforming to ASTM D 4956 Type IV, Class 1. The band shall be 10 inches wide along
both sides, the full length of the truck and across the front (space permitting), and be in a
plane with the headlights. The roof and upper part of the cab, down to a line at the
bottom of the windshield, shall be painted the manufacturer's standard gloss white. The
equipment compartments shall be painted with spatter type paint and the cab interior
shall be painted with black wrinkle paint. A command fire department logo, either
magnetic or decal, may be applied to the center area of the front doors of the truck cab.
c. ISO Containers. ISO Containers shall display identification numbering
system required by OPNAVINST 4620.10, Joint Procedures for Implementing the
International Safe Container Act.
d. Seabee Insignia. To readily identify NCF equipment, a yellow Seabee
insignia shall be painted on all assigned equipment. NOTE: If yellow does not contrast,
the Seabee shall be painted black.
Recommended stenciling locations for the Seabee emblems are listed in Appendix J.
These recommendations shall be closely adhered to. If the recommended location has
less than 8-inch width or height, the stencil shall be centered, with the Seabee itself
shown upon the equipment, without concern for the trim. If space does not permit this, a
4-inch stencil may be used. If there is doubt about the proper stenciling location,
contact CESO Code 1575. Stencils may be requisitioned from NCBC Port Hueneme or
NCBC Gulfport, using the data below, and a funded requisitioning document.
NSN Description U/I
7520-00-067-8434 Stencil, Insignia Seabee 8" ea
7520-01-160-9554 Stencil, Insignia Seabee 4" ea
e. Octopus Insignia. To readily identify CESE assigned to the U.S. Navy
Cargo Handling and Port Group, a yellow Octopus insignia shall be painted on all
assigned equipment. The recommended stenciling locations shown in Appendix J shall
be closely adhered to.
. f. Lifting Device Markings. Lifting devices shall be painted yellow and
identified by the words "LIFT HERE" stenciled in 1-inch black letters on a visible area
next to the lifting device.
g. Tire Pressure Markings. The recommended tire pressure shall be stenciled
in 1-inch black figures on a visible area above each tire on all vehicles (except sedans)
with pneumatic tires. A correct example for a vehicle with tires that require 25-pound
pressure is "TP-25."
2-59