NAVFAC P-300 Management of Transportation Equipment

Attachment Identification numbers (Table D-1) are two inches high and shall be
permanently welded to that portion of each attachment least subject to normal
wear. Where it is not desirable to weld directly on the attachment, as in the case
of crane booms and hooks, the ID number shall be welded on a metal plate of
appropriate size and then permanently fixed to the attachment.
b. USNG-Numbered ISO Containers. ISO containers are USNGnumbered
items which are recorded as attachments and managed like CESE.
3. Attachment ID Number Assignment. Attachments to CESE are not
assigned permanently Navy numbers until they reach the initial Allowance
Holder. Therefore, units may receive attachments that do not have permanent
ID numbers. In this event, the following procedures are necessary.
a. ID Number Request. The receiving activity shall request an ID
number by initiating an Equipment Attachment Registration Record Card,
NAVFAC Form 6-11200/45 (Figure D-1) for each attachment. After this
registration card is completed in accordance with the following instructions, two
copies shall be submitted to CESO (Code 1575) via the Allowance Holder, if
appropriate. Retain one copy in the appropriate equipment history jacket.
Block Remarks
1 From Column 1 to the Equipment Shipping Specification.
2 thru 12 Self-explanatory.
13 thru 16 If attachment is peculiar to only one type machine, complete
these blocks.
17 All items, such as shear-leg, crowd and rehaul assembly,
lagging, high and low gantry.
18 USN number to which assigned.
19 and 20 Self-explanatory.
21 CESO will complete.
22 Enter if known; if unknown, CESO will complete.
D-2