Technical Manual TNC 360 - heidenhain - DR. JOHANNES ...

6.6 Cycles 4-126
6.6.1 Cycle inhibit 4-126
6.6.2 Pocket milling 4-128
6.6.3 Milling-cycles for pockets with free-programmed contours 4-128
6.6.4 Scaling factor 4-130
6.7 File types 4-132
6.7.1 File types – disable 4-132
6.7.2 Block numbers - step size for ISO programs 4-132
6.8 User parameters 4-132
6.9 Code numbers 4-133
6.10 Programming station 4-134
6.11 Dialog language 4-134
6.12 Decimal sign 4-134
6.13 Memory test 4-135
6.14 End of program run 4-135
6.15 Overwrite Q-parameters overwriting 4-135
7 M Functions 4-137
7.1 Program halt on M functions 4-140
7.2 Program halt on M06 4-140
7.3 M function M89 4-140
8 Key Simulation 4-141
8.1 TNC Keyboard 4-141
8.2 Machine control panel 4-149
9 Touch Probe 4-151
9.1 Interfacing the touch probe 4-151
9.2 Digitizing with TS 120 4-155
9.2.1 Scanning cycles 4-158
9.2.2 Response of the scanning sequence at corners 4-159
9.2.3 Optimizing the scanning sequence 4-161
10 Electronic Handwheel 4-166
10.1 Panel-mounted handwheel HR 130 4-169
10.2 Portable handwheel HR 330 4-169
10.3 Portable handwheel HR 332 4-169
10.3.1 Assignment of keys and LEDs to the PLC inputs and outputs 4-170
10.3.2 PLC example 4-171
10.4 Panel-mounted handwheels HR 150 with handwheel adapter HRA 110 4-172
10.4.1 Assignment of the switch setting to the PLC inputs 4-173
10.4.2 PLC Example 4-174
11 Analog Inputs 4-176
8/95 TNC 360 1 Machine Axes 4-3