Technical Manual TNC 360 - heidenhain - DR. JOHANNES ...

3.1.8 ASSIGN BYTE (B=) B=
Abbreviation for the PLC Editor: B= (ASSIGN BYTE)
Execution time [µs] 26.0
Number of bytes 14
Operands: M, I, O, T, C
Operation:
With the command B=, 8 bits are copied from the Word Accumulator to Markers, Inputs, Outputs,
Timers or Counters with ascending numbering. Each bit corresponds to 1 operand. The LSB in the
Accumulator is copied to the designated operand address, the LSB + 1 to the designated address +
1 and so on. The last affected operand is occupied by the MSB.
3.1.9 ASSIGN WORD (W=) W=
Abbreviation for the PLC Editor: W= (ASSIGN WORD)
Execution time [µs] 50
Number of bytes 14
Operands: M, I, O, T, C
Operation:
With the command W=, 16 bits are copied from the Word Accumulator to Markers, Inputs,
Outputs, Timers or Counters with ascending numbering. Each bit corresponds to 1 operand. The
LSB in the Accumulator is copied to the designated operand address, the LSB + 1 to the designated
address + 1 and so on. The last affected operand is occupied by the MSB.
3.1.10 ASSIGN DOUBLEWORD (D=)D=
Abbreviation for the PLC Editor: D= (ASSIGN DOUBLE)
Execution time [µs] 104.4
Number of bytes 14
Operands: M, I, O, T, C
Operation:
With the command D=, 32 bits are copied from the Word Accumulator to Markers, Inputs, Outputs,
Timers or Counters with ascending numbering. Each bit corresponds to 1 operand. The LSB in the
Accumulator is copied to the designated operand address, the LSB + 1 to the designated address +
1 and so on. The last affected operand is occupied by the MSB.
7-36 TNC 360 3 Commands 8/95