Scan Tool Operating Instructions - AK Automotive Training

Manufacturer Applications
Engine Codes: ANA
Display Description
Code
1 Lambda 1. Engine speed.
Control 2. Engine coolant temperature.
3. Lambda control (see note below)
4. Operating condition (for the relevance of this display line, see Table
53).
NOTE: Minus value indicates a weak mixture, positive value indicates a rich mixture
2 Injection 1. Engine speed.
Duration 2. Engine load.
3. Injection duration.
4. Intake air mass.
3 Ignition 1. Engine speed.
Timing 2. Intake air mass (engine load).
3. Throttle valve angle sensor 1.
4. Ignition timing.
4
1. Engine speed.
Temperature 2. ECU supply voltage.
3. Engine coolant temperature.
4. Intake air temperature.
5 Operating 1. Engine speed.
Mode 2. Engine load.
3. Vehicle speed.
4. Operating mode (idle, part load, etc.).
6 Altitude 1. Engine speed
Correction 2. Engine load.
3. Intake air temperature.
4. Altitude correction factor (see note below).
NOTE: At sea level value should be +5 to -10
1000m value should be -5 to -20
2000m value should be -10 to -30
10 Ignition 1. Engine speed.
2. Engine load.
3. Throttle valve angle.
4. Ignition timing.
12 Distributor 1. Engine speed.
Settings 2. Engine load.
3. No. of the teeth on the crank sender wheel when the Hall sensor
signal changes from - to + (see note below).
4. No. of teeth on the crank sender wheel when the Hall sensor signal
changes from + to - (see note below).
161