Scan Tool Operating Instructions - AK Automotive Training

FastCheck
Read DTCs
If any DTC codes are present in the system, a screen will be displayed informing you
how many codes were found. This will then be replaced by the first DTC code. DTC
codes are generated according to the vehicle and system manufacturer.
The fault number is displayed first, followed by the DTC code. If the description text
is too long to fit on the display, '[...]' appears in the bottom right corner of the screen.
This indicates that the text can be scrolled using the and keys to view the rest
of the description.
To view the next DTC (if more than 1 was found), scroll to the end of the text and press
the key.
To return to the menu, scroll to the end of the text and press the key.
Clear DTCs
Diagnostic trouble codes can be cleared using the 'Clear DTCs' option. When using
the option you will be prompted to turn the ignition off. Wait until prompted before
switching the ignition back on.
Start the engine to force the control module to run a system check. Verify that the
code(s) have been cleared by selecting 'Read DTCs'.
NOTE: Reading DTC(s) without first starting the engine will only confirm that the
stored DTC(s) have been cleared. Faults may still be present in the system causing
a DTC to be stored next time the engine is started.
BMW/MINI Vehicles
NOTE: To switch the ignition ON procedure for vehicles fitted with a start/stop, insert
the remote key-fob fully into the ignition slot then press the start/stop button once
(without any foot pedals depressed).
32