Scan Tool Operating Instructions - AK Automotive Training

Manufacturer Applications
Mercedes
If the vehicle under test has both the round diagnostic connector and the J1962 (16
pin) connector, the round connector should always be used to access information via
the Mercedes application and the J1962 connector should be used to access data via
the EOBD application.
Sensotronic BC
WARNING:
• Always deactivate the Sensotronic BC before carrying out any maintenance
work.
• Only fully-qualified technicians should carry out work on the brake system.
They must be familiar with modern brake systems.
• Only carry out maintenance work when the vehicle is stationary.
• Only carry out maintenance work on the brake after the system has been
deactivated.
• Upon deactivation, a warning message should appear in the instrument
panel and an audible warning signal is heard until the maintenance work is
complete and the system reactivated.
• If the warning signals do not occur, assume that the system is not fully
deactivated and do not carry out any maintenance work.
NOTE: Omitec Group accept no responsibility for any accident or injury arising from
the maintenance of the Sensotronic brake system.
From the sub-menu select the Control Module and follow the on-screen instructions.
The OmiCheck will attempt to establish communications with the vehicle. Once
established, follow the on screen instructions for each test.
On selecting the item the following sub-menu will be displayed:
1. Read Faults
2. Clear Faults
244