Scan Tool Operating Instructions - AK Automotive Training

FastCheck
Pre-Test conditions:
• The vehicle must be stationary
• The vehicle must be on level ground
• The vehicle must be secured with wheel locks
It should be used if it is suspected that there is a fault with the Control Module, wiring,
or the actuators (if the parking brake will not engage/disengage when manually
operated).
NOTE: This function can not be performed while the parking brake system is in
maintenance mode. It should only be performed when the system is in normal
operating mode.
Configuration
There are two functions available under the ‘Configuration’ menu option:
Inclination Sensor Calibration
This function is used to reset the stored zero value of the inclination sensor. It should
be used when a new Parking Brake module has been fitted or a new Inclination
sensor has been fitted.
Pre-Test conditions:
• The operator must NOT be inside the vehicle
• The vehicle must be stationary
• The vehicle must be on level ground
• Ensure the vehicle is not subject to any vibration (closing boot, bonnet, etc)
• The vehicle must be secured with wheel locks
NOTE: This function cannot be performed while the parking brake system is in
maintenance mode. It should be performed when the system is in normal operating
mode.
Clear Stored Clutch Engagement Point
This function is used to reset the stored value of the clutch engagement point. It
should be used when a new Parking Brake module has been fitted or a new clutch
has been fitted. This function is only applicable to vehicles with manual transmission.
38