Scan Tool Operating Instructions - AK Automotive Training

Manufacturer Applications
BMW
NOTE: To switch the ignition ON procedure for vehicles fitted with a start/stop, insert
the remote key-fob fully into the ignition slot then press the start/stop button once
(without any foot pedals depressed).
The vehicle's diagnostic connector (20-pin round connector) is always found in the
engine compartment. If the vehicle is fitted with a J1962 diagnostic connector, this
can usually be located in the driver's footwell behind a cover.
NOTE: If the BMW vehicle under test has both the round (20 pin) diagnostic connector
and the J1962 (16 pin) connector, the round connector should always be used to
access information via the BMW application and the J1962 connector should be used
to access data via the EOBD application (ensure the cap is fitted to the 20-pin
connector). If the cap is not fitted, the J1962 connector will not function correctly.
Application Menu
Select BMW from the Main Menu. From the sub-menu select the required system e.g.
EMS (Engine Management System), ABS or Airbag etc.
EMS Sub Menu
Select the applicable harness from the system menu. The application will
automatically detect the ECU during which time you will see the Establishing
Communications Please Wait Message. Once the ECU has been recognised, the
EMS menu will be displayed.
Service Reset
Resets the oil and inspection service lights and Condition Based Service (CBS)
options.
Use the on screen instructions to select the reset option required, refer to Service
section in the manual for more detailed instructions.
NOTE: The Motronic 1.7/1.71f and 1.7rt fault listing information should be referenced
when interrogating a Motronic 1.7.2 system.
Citroen and Peugeot
Particle Filter (FAP)
PSA were the first Vehicle manufacturer to introduce the Particle Emissions Filter
(PEF or FAP). The purpose of the filter is to considerably reduce emissions from
diesel injected engines.
As well as the standard functions such as Read/Clear DTCs and Live Data there are
a number of configuration functions available for the Particle Filter and the Additive
194