Scan Tool Operating Instructions - AK Automotive Training

FastCheck
Select Condition Based Service (CBS):
NOTE: All required work must be carried out before service indicators are reset.
Failure to do so may result in incorrect service values and cause DTCs to be stored
by the relevant control module.
NOTE: The DSC module will not recognise the replacement of the brake pad wear
sensor before a terminal change has taken place. As such the DSC module will not
allow reset of the brake pad service items.
It is recommended that the brake pads are replaced with genuine BMW parts. The
DSC module may not recognise a terminal change if using non-genuine brake pads.
Select Condition Based Service (CBS) for vehicles only fitted with a J1962 16 pin
connector and support Condition Based Service (CBS).
Applicable vehicles:
BMW 1 series (E81/E87)
BMW 3 series (E90/E91/E92/E93)
BMW 5 series (E60/E61)
BMW 6 series (E63/E64)
BMW 7 series (E65)
BMW X5 (E70)
BMW X6 (E71)
MINI (R55/R56/R57)
NOTE: Refer to the ‘Vehicle Application List’ to determine the correct cable.
Condition Based Service (CBS) is a system in which the vehicle calculates and
monitors the status of serviced components and fluid levels as well as time and
mileage based services.
56