Scan Tool Operating Instructions - AK Automotive Training

FastCheck
Exit Service Mode
This function is used to put the system back into an operational state after work has
been carried out by the technician. Callipers are closed to the applied position, and
normal operation is available again.
Pre-Test conditions:
• The vehicle must be stationary
• The vehicle must be on level ground
• The vehicle must be secured with wheel locks.
This function takes 10 seconds to complete.
Ensure the on screen instructions on the service tool are followed precisely and in the
correct order.
Installation Check
This function is used to check the operation of the parking brake system after any
work has been completed on the system.
Pre-Test conditions:
• The vehicle must be stationary
• The vehicle must be on level ground
• The vehicle must be secured with wheel locks.
Three internal tests are performed, each will report the status. If any of these tests fail
to perform the Read DTCs function to detect the possible fault with the system.
This function takes 25 seconds to complete.
NOTE: This function cannot be performed while the parking brake system is in service
mode. It should only be performed when the system is in normal operating mode.
Ensure the on screen instructions on the service tool are followed precisely and in the
correct order.
48