Scan Tool Operating Instructions - AK Automotive Training

SAS (Steering Angle Sensor)
49
FastCheck
Connection
Using the Vehicle Application List on the CD-ROM, identify the required interface
cable for the vehicle system to be tested. Connect the cable to the OmiCheck and
secure the fixing screws.
NOTE: If the vehicle being tested is a BMW with a 20 pin connector and an OBD-II
connector, you must only use the 20 pin connector.
Ensure the vehicle’s ignition is OFF.
Connect the OmiCheck to the required vehicle connector, refer to ‘Diagnostic
Connector Locations’, page 271, for further information.
Power for the OmiCheck is provided by the vehicle connector. Once connected, the
OmiCheck will perform an internal self test and then the screen will display the date
of the current software version before displaying the main menu.
MAIN MENU
1. EOBD
2. FastCheck ABS
3. FastCheck Airbag
4. FastCheck Climate
5. FastCheck EPB
6. FastCheck SAS
7. FastCheck Service
8. FastCheck TPMS
9. User Menu
Use the and keys to select the 'SAS' application and press to confirm the
selection. To return to the previous menu, press the
Turn the vehicle's ignition ON.
key.
Use the
selection.
and keys to select the vehicle manufacturer and press to confirm the
Dependent upon the vehicle manufacturer and application being run, you may be
asked to choose the particular system fitted to the vehicle. Select the correct system
using the and keys and press to confirm.
1. Read DTCs
2. Clear DTCs
3. SAS Calibration
Select the required menu option using the and keys and press to confirm.