Scan Tool Operating Instructions - AK Automotive Training

Pre-CAN vehicles
63
FastCheck
This function should be used after a vehicle has been serviced.
The vehicle is programmed with the number of miles and days (which ever one occurs
first) until the next service and the Service Indicator light is turned off.
The reset is started by selecting the 'Service’ option.
To return to a previous menu, press the key.
Please ensure that the vehicle is stationary and check that all the vehicle's doors are
closed.
Press on the OmiCheck to reset the Service Interval.
If successful the OmiCheck will display 'Service Reset Passed'.
Long-Life Oil Reset
CAN Vehicles - (Vectra-C and Signum)
NOTE: The engine must NOT be running when performing this procedure.
This function must be used when an Engine Oil Change has been performed on the
vehicle.
The Long-Life Oil Reset is started by selecting the ‘Long-Life Oil’ option.
The Technician must then select the cable to be used.
The OmiCheck will check the Engine Control Module to ensure that the function is
supported for the current engine. This function is not supported and not necessary on
Astra-H, Corsa-D or Zafira-B.
The OmiCheck will check the Engine Speed to ensure that the engine is NOT running
then read the current value of ‘Remaining Oil Life’ from the Engine Control Module
and display. If the value is less than 15% the Oil MUST be changed and a reset
performed.
The OmiCheck will then perform the Reset. The ‘Remaining Oil Life’ parameter will
be read from the Engine Control Module and displayed again. It will read 100% if the
reset has been successful.