Scan Tool Operating Instructions - AK Automotive Training

FastCheck
Service Interval
This option resets the conventional service interval indicator. This function is to be
used AFTER a full service (18000 miles for petrol or 21000 miles for diesel) has been
completed on the vehicle.
Oil Change Reset
This option is currently only applicable to the new Fiat Ducato van (Ducato III MY2006
onwards). This function is to be used AFTER an Oil Change has been completed on
the vehicle.
Oil Degradation Counter Reset
This option is necessary on vehicles which have Diesel Particulate Filters (DPF)
fitted. This is NOT necessary on vehicles with petrol or LPG engines or diesel engines
if DPF is not fitted. When selected the OmiCheck will interrogate the vehicle to
determine the applicability of the function.
This function allows the resetting of the Oil Degradation Counter and viewing of the
Oil Degradation parameters (number of resets, Oil Degradation Counter %, km until
next reset required, odometer at last reset). The counter should only be reset AFTER
the Oil has been changed. When reset the Counter will be reset to 100%, the number
of resets will increase by 1.
Alfa Romeo Vehicles Mannesman Dashboard (147 and GT - UK only)
For Alfa Romeo vehicles with the Mannesman Dashboard (147 and GT) there is a
problem with the Dashboard which causes the ‘Number of miles to Service’ value to
be set to zero when a Service Reset is performed using the OmiCheck.
When the Service Reset is performed the Dashboard stores the current mileage (or
kilometre) value, read from the Odometer, in order to calculate when the next service
is required.
However, when the Odometer is shown in miles the calculation for the distance to the
next service fails. This results in distance to the next service being displayed as zero
and the Service Reset fails to be completed.
To reset the Service Interval the following procedure must be performed:
1. Switch the Ignition ON.
2. Press the [MODE] button on the dashboard to enter the dashboard functions
menu.
3. Use the [+] and [-] buttons on the dashboard to navigate to the UNITS option and
press [MODE] to select.
4. Use the [MODE], [+] and [-] buttons to set the units to Kilometres. All other
settings should be left unchanged.
5. Use the [+] and [-] buttons on the dashboard to navigate to the END MENU option
54