Scan Tool Operating Instructions - AK Automotive Training

Service
53
FastCheck
Connection
Using the Vehicle Application List on the CD-ROM, identify the required interface
cable for the vehicle system to be tested. Connect the cable to the OmiCheck and
secure the fixing screws.
NOTE: If the vehicle being tested is a BMW fitted with both a 20 pin connector and an
OBD-II connector, you must only use the 20 pin connector.
NOTE: If the vehicle being tested is a Mercedes fitted with both a 38 pin connector
and an OBD-II connector, you must only use the 38 pin connector.
Ensure the vehicle's ignition is OFF.
Connect the OmiCheck to the required vehicle connector, refer to ‘Diagnostic
Connector Locations’, page 271, for further information.
Power for the OmiCheck is provided by the vehicle connector. Once connected, the
OmiCheck will perform an internal self test and then the screen will display the date
of the current software version before displaying the main menu.
MAIN MENU
1. EOBD
2. FastCheck ABS
3. FastCheck Airbag
4. FastCheck Climate
5. FastCheck EPB
6. FastCheck SAS
7. FastCheck Service
8. FastCheck TPMS
9. User Menu
Use the and keys to select the 'Service' application and press to confirm the
selection. To return to the previous menu, press the
Turn the vehicle's ignition ON.
key.
Use the
selection.
and keys to select the vehicle manufacturer and press to confirm the
Dependent upon the vehicle manufacturer and model different menu options will then
be available.
Alfa Romeo/Fiat/Lancia vehicles
There are potentially three options in the Service menu for these manufacturers: