Scan Tool Operating Instructions - AK Automotive Training

More documents

Recommendations

Info

Manufacturer Applications 6 1. Lambda factor. 2. Learned idling adaption value (specification range not currently available). 3. Learned part load adaption value (specification range not currently available). 4. Learned full load adaption value (specification range not currently available). 87
Manufacturer Applications Table 3 - Engine Code AEK Relevant when '1' is displayed in the 5-digit block X X X X X Display Group 4 Display Group 5 1 Overrun Not relevant 1 Idling Signal from AT 1 Part load N/A 1 Full load A/C stand-by 1 Acceleration A/C compressor switched on Engine Code: ABF (Digifant 3.0) Display Description Group 1 1. Coolant temperature. 2. Engine speed. 3. Lambda probe voltage. 4. Injection period 2 1. Coolant temperature. 2. Engine speed. 3. Throttle valve angle. Calculated figure, (dependent on throttle valve potentiometer). 4. Injection period. 3 1. Coolant temperature. 2. Engine speed. 3. Intake air temperature. 4. Battery voltage. 4 1. Coolant temperature. 2. Engine speed. 3. Ignition timing. Calculated figure (this value must not be used to check or adjust ignition timing). 4. Engine load. 5 1. Coolant temperature. 2. Engine speed. 3. Throttle valve angle. Calculated figure, (dependent on throttle valve potentiometer). 4. Battery voltage. Engine Code: ABF (Digifant 3.2) Display Description Group 1 1. Engine speed 2. Coolant temperature. 3. Lambda probe voltage. 4. Adjustment conditions (see Table 4 for the relevance of these figures). 88
Page 1 and 2:
OmiCheck Operating Instructions www
Page 3 and 4:
Contents Introduction Overview.....
Page 5 and 6:
Contents Appendix D: Manual Service
Page 7 and 8:
Introduction Kit Contents The OmiCh
Page 9 and 10:
Introduction Connection 1 OM1568 2
Page 11 and 12:
Introduction Safety Precautions The
Page 13 and 14:
Introduction Troubleshooting Proble
Page 15 and 16:
Introduction Specification OmiCheck
Page 17 and 18:
EOBD Identifying Compliant Vehicles
Page 19 and 20:
EOBD Interpreting EOBD Fault Codes
Page 21 and 22:
EOBD 1. EOBD OPERATIONS MIL Status
Page 23 and 24:
EOBD O2 Sensor Tests EOBD has an op
Page 25 and 26:
EOBD Main Menu Availability Manufac
Page 27 and 28:
FastCheck Safety Instructions WARNI
Page 29 and 30:
FastCheck ABS (Anti-lock Braking Sy
Page 31 and 32:
FastCheck Clear DTCs Diagnostic tro
Page 33 and 34:
FastCheck Read DTCs If any DTC code
Page 35 and 36:
FastCheck The Disarm Passenger (LOC
Page 37 and 38:
FastCheck Read DTCs If any DTC code
Page 39 and 40:
FastCheck Dependent upon the vehicl
Page 41 and 42: FastCheck The operator will be aske
Page 43 and 44: FastCheck Pre-Test conditions: •
Page 45 and 46: FastCheck Any other EPB system comp
Page 47 and 48: FastCheck Latching Position This pr
Page 49 and 50: FastCheck Renault - Handbrake There
Page 51 and 52: FastCheck Replace Pads Select the R
Page 53 and 54: FastCheck Exit Service Mode This fu
Page 55 and 56: FastCheck The OmiCheck will attempt
Page 57 and 58: FastCheck Fiesta (2008 -), Fusion/B
Page 59 and 60: FastCheck Service Interval This opt
Page 61 and 62: FastCheck Select Condition Based Se
Page 63 and 64: FastCheck The estimated distance to
Page 65 and 66: FastCheck Annual Distance: The aver
Page 67 and 68: FastCheck Corsa D The number of mil
Page 69 and 70: FastCheck Land Rover vehicles There
Page 71 and 72: FastCheck NOTE: Services which have
Page 73 and 74: FastCheck Variable Service Reset (V
Page 75 and 76: FastCheck Citroen, Peugeot, Fiat an
Page 77 and 78: FastCheck Renault (Type 2) With the
Page 79 and 80: FastCheck • Drive off. The Reset
Page 81 and 82: FastCheck OM1346 • The Warning La
Page 83 and 84: Manufacturer Applications Audi, Sea
Page 85 and 86: Manufacturer Applications Adding tr
Page 87 and 88: Manufacturer Applications Engine Co
Page 89 and 90: Manufacturer Applications Table 1 -
Page 91: Manufacturer Applications Table 2 -
Page 95 and 96: Manufacturer Applications Table 4 -
Page 97 and 98: Manufacturer Applications 11 1. Eng
Page 99 and 100: Manufacturer Applications 5 1. Engi
Page 107 and 108: Manufacturer Applications 7 1. Idli
Page 109 and 110: Manufacturer Applications 7 1. Lamb
Page 111 and 112: Manufacturer Applications 19 1. Eng
Page 113 and 114: Manufacturer Applications Table 15
Page 115 and 116: Manufacturer Applications NOTE 1: L
Page 119 and 120: Manufacturer Applications 13 1. Ign
Page 121 and 122: Manufacturer Applications NOTE: Tot
Page 135 and 136: Manufacturer Applications 15 1. Kno
Page 137 and 138: Manufacturer Applications Table 24
Page 139 and 140: Manufacturer Applications Table 26-
Page 141 and 142: Manufacturer Applications Table 27-
Page 143 and 144:
Manufacturer Applications NOTE: A l
Page 145 and 146:
Manufacturer Applications 25 System
Page 147 and 148:
Manufacturer Applications 3 1. Engi
Page 149 and 150:
Manufacturer Applications 21 Lambda
Page 151 and 152:
Manufacturer Applications 3 EGR Sys
Page 153 and 154:
Manufacturer Applications Table 33
Page 155 and 156:
Manufacturer Applications 4 Injecti
Page 157 and 158:
Page 159 and 160:
Manufacturer Applications 2 Idling
Page 161 and 162:
Page 163 and 164:
Manufacturer Applications 7 Tempera
Page 165 and 166:
Page 167 and 168:
Manufacturer Applications NOTE: The
Page 169 and 170:
Page 171 and 172:
Page 173 and 174:
Page 175 and 176:
Page 177 and 178:
Page 179 and 180:
Page 181 and 182:
Manufacturer Applications 56 Idle S
Page 183 and 184:
Page 185 and 186:
Manufacturer Applications 16 Knock
Page 187 and 188:
Page 189 and 190:
Page 191 and 192:
Page 193 and 194:
Manufacturer Applications Basic Set
Page 195 and 196:
Manufacturer Applications Re-coding
Page 197 and 198:
Manufacturer Applications Variable
Page 199 and 200:
Manufacturer Applications BMW NOTE:
Page 201 and 202:
Manufacturer Applications Regenerat
Page 203 and 204:
Manufacturer Applications A fault c
Page 205 and 206:
Manufacturer Applications 3. Wait f
Page 207 and 208:
Manufacturer Applications Inter-cha
Page 209 and 210:
Manufacturer Applications Bosch M7.
Page 211 and 212:
Manufacturer Applications Magneti M
Page 213 and 214:
Manufacturer Applications 13. Befor
Page 215 and 216:
Manufacturer Applications Fiat, Alf
Page 217 and 218:
Manufacturer Applications 4. The en
Page 219 and 220:
Manufacturer Applications When the
Page 221 and 222:
Manufacturer Applications Self Test
Page 223 and 224:
Manufacturer Applications KO ER Tes
Page 225 and 226:
Manufacturer Applications OM1349 OM
Page 227 and 228:
Manufacturer Applications OM1352 1.
Page 229 and 230:
Manufacturer Applications OM1354 2.
Page 231 and 232:
Manufacturer Applications Live Data
Page 233 and 234:
Manufacturer Applications A feature
Page 235 and 236:
Manufacturer Applications Clear Fau
Page 237 and 238:
Manufacturer Applications to re-rea
Page 239 and 240:
Manufacturer Applications Honda ALB
Page 241 and 242:
Manufacturer Applications Clear Fau
Page 243 and 244:
Manufacturer Applications Transmitt
Page 245 and 246:
Manufacturer Applications Pre-test
Page 247 and 248:
Manufacturer Applications Pre-test
Page 249 and 250:
Manufacturer Applications Mercedes
Page 251 and 252:
Manufacturer Applications If the Om
Page 253 and 254:
Manufacturer Applications 72 Pyrote
Page 255 and 256:
Manufacturer Applications Renault E
Page 257 and 258:
Manufacturer Applications Renault T
Page 259 and 260:
Manufacturer Applications Renault (
Page 261 and 262:
User Menu Tester Setup The tester s
Page 263 and 264:
User Menu Security Most of the appl
Page 265 and 266:
Glossary of terms Term Description
Page 267 and 268:
262 Appendix A: Glossary ESV (Drive
Page 269 and 270:
MPH miles per hour MST Manifold Sur
Page 271 and 272:
TVV Thermal Vacuum Valve TWC Three
Page 273 and 274:
CR0231 CR0230 OG2013 - PSA 30 pin c
Page 275 and 276:
CR0228 CR0235 OG2002 - BMW cable OG
Page 277 and 278:
Appendix C: Diagnostic Connector Lo
Page 279 and 280:
Page 281 and 282:
Page 283 and 284:
Page 285 and 286:
Page 287 and 288:
Page 289 and 290:
Page 291 and 292:
Appendix D: Manual Service Reset Au
Page 293 and 294:
Appendix D: Manual Service Reset NO
Page 295 and 296:
Appendix D: Manual Service Reset C3
Page 297 and 298:
Appendix D: Manual Service Reset Re
Page 299 and 300:
Appendix D: Manual Service Reset Xs
Page 301 and 302:
Appendix D: Manual Service Reset Fi
Page 303 and 304:
Appendix D: Manual Service Reset GM
Page 305 and 306:
Appendix D: Manual Service Reset La
Page 307 and 308:
Appendix D: Manual Service Reset Pe
Page 309 and 310:
Appendix D: Manual Service Reset 40
Page 311 and 312:
Appendix D: Manual Service Reset Bo
Page 313 and 314:
Appendix D: Manual Service Reset Re
Page 315 and 316:
Appendix D: Manual Service Reset La
Page 317 and 318:
Appendix D: Manual Service Reset Ve
Page 319 and 320:
Appendix D: Manual Service Reset Vo
Page 321 and 322:
Page 323 and 324:
Page 325:
Omitec Hopton Industrial Estate Lon
show all

Scan Tool Operating Instructions - AK Automotive Training

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?