Scan Tool Operating Instructions - AK Automotive Training

Magneti Marelli 4MP2 Engine Code 3FZ (2.2i)
Manufacturer Applications
Procedure:
1. Switch the ignition off then on.
2. OmiCheck sends the command to reset.
3. Switch the ignition off then on again.
4. Wait for 10 seconds.
5. Start the engine.
6. Run the engine at idle until the fans cut-in (Air conditioning must be off).
7. Switch off the ignition to store the new values.
8. Wait for 12 minutes while the CM powers down
9. Switch on the ignition.
10. Wait for 15 seconds
11. Start the engine.
12. Before returning the vehicle to the customer a test drive should be undertaken
during which time an injection cut-off should be triggered. This is achieved by
driving the vehicle in 3rd, 4th or 5th gear and sharply releasing the accelerator
pedal without braking.
Magneti Marelli 6LP Engine Code RFN (2.0i)
Procedure:
IMPORTANT: Do not start the engine for 10 minutes before carrying out this
operation.
• The engine coolant temperature must be below 30°C
• The air conditioning must be set to off
1. OmiCheck sends the command to reset.
2. Switch off the ignition to allow the CM to reset.
3. Wait for 15 seconds.
4. Switch on the ignition and listen for the EGR Valve clicking.
5. Wait for 15 seconds.
6. If the EGR Valve does not click the procedure must be restarted.
7. Switch off the ignition to store the new values.
8. Wait for 15 minutes while the CM powers down.
9. Switch on the ignition.
10. Wait for 15 seconds.
11. Start the engine.
12. Run the engine at idle until the fans cut-in (Air conditioning must be off).
207