Scan Tool Operating Instructions - AK Automotive Training

More documents

Recommendations

Info

Read Faults Manufacturer Applications TYPE A: Ensure ignition has been turned OFF for 10 seconds or longer, bridge 2-pin data link connector terminals. Turn ignition ON, Type B: Faults on this system can only be read from the SRS (Supplementary Restraint Systems) warning lamp which is situated on the left hand side of the steering wheel under a cover. TYPE C: Ensure ignition is turned OFF, bridge 2-pin data link connector terminals. Turn ignition On. Clear Faults TYPE A: Ensure ignition is turned off, bridge memory erase connector (2-pin) which is located to the right of the steering column under the facia panel) Turn ignition ON, SRS warning lamp illuminates for 6 seconds. Disconnect bridge wire within 4 seconds of SRS warning lamp extinguishing. SRS lamp illuminates, bridge connector terminals within 4 seconds of warning lamp illuminating. SRS lamp extinguishes. Disconnect bridge wire within 4 seconds of warning lamp extinguishing. SRS warning lamp flashes twice. Switch ignition OFF - trouble code should be cleared. TYPE B: Switching OFF ignition clears fault codes. TYPE C: Ensure ignition is turned off, bridge memory erase connector (2-pin), which is located to the right of the steering column under the facia panel. Turn ignition ON, SRS warning lamp illuminates for 6 seconds. Disconnect bridge wire within 4 seconds of SRS warning lamp extinguishing. SRS lamp illuminates, bridge connector terminals within 4 seconds of warning lamp illuminating. SRS lamp extinguishes. Disconnect bridge wire within 4 seconds of warning lamp extinguishing. SRS warning lamp flashes twice. Switch ignition OFF - Wait a few seconds. Turn ignition ON SRS warning lamp illuminates for 6 seconds. Check that SRS warning lamp does not illuminate after 30 seconds. Turn ignition OFF. Transmission Vehicle Years Civic 1991-2000 Accord 1993-1998 Read Faults Fault codes for either vehicle can be accessed via the 2 pin data link connector by bridging the terminals on the 2 pin data link connector and turning the ignition on. 235
Manufacturer Applications Clear Faults To clear codes, follow this procedure: • Switch ignition off. • Remove bridge wire. • Remove back up (radio) fuse (7.5A) from under bonnet fusebox for 10 seconds. • Refit fuse. NOTE: Disconnecting this fuse will erase any memory from in-car entertainment or electronic clocks. 236
Page 1 and 2:
OmiCheck Operating Instructions www
Page 3 and 4:
Contents Introduction Overview.....
Page 5 and 6:
Contents Appendix D: Manual Service
Page 7 and 8:
Introduction Kit Contents The OmiCh
Page 9 and 10:
Introduction Connection 1 OM1568 2
Page 11 and 12:
Introduction Safety Precautions The
Page 13 and 14:
Introduction Troubleshooting Proble
Page 15 and 16:
Introduction Specification OmiCheck
Page 17 and 18:
EOBD Identifying Compliant Vehicles
Page 19 and 20:
EOBD Interpreting EOBD Fault Codes
Page 21 and 22:
EOBD 1. EOBD OPERATIONS MIL Status
Page 23 and 24:
EOBD O2 Sensor Tests EOBD has an op
Page 25 and 26:
EOBD Main Menu Availability Manufac
Page 27 and 28:
FastCheck Safety Instructions WARNI
Page 29 and 30:
FastCheck ABS (Anti-lock Braking Sy
Page 31 and 32:
FastCheck Clear DTCs Diagnostic tro
Page 33 and 34:
FastCheck Read DTCs If any DTC code
Page 35 and 36:
FastCheck The Disarm Passenger (LOC
Page 37 and 38:
FastCheck Read DTCs If any DTC code
Page 39 and 40:
FastCheck Dependent upon the vehicl
Page 41 and 42:
FastCheck The operator will be aske
Page 43 and 44:
FastCheck Pre-Test conditions: •
Page 45 and 46:
FastCheck Any other EPB system comp
Page 47 and 48:
FastCheck Latching Position This pr
Page 49 and 50:
FastCheck Renault - Handbrake There
Page 51 and 52:
FastCheck Replace Pads Select the R
Page 53 and 54:
FastCheck Exit Service Mode This fu
Page 55 and 56:
FastCheck The OmiCheck will attempt
Page 57 and 58:
FastCheck Fiesta (2008 -), Fusion/B
Page 59 and 60:
FastCheck Service Interval This opt
Page 61 and 62:
FastCheck Select Condition Based Se
Page 63 and 64:
FastCheck The estimated distance to
Page 65 and 66:
FastCheck Annual Distance: The aver
Page 67 and 68:
FastCheck Corsa D The number of mil
Page 69 and 70:
FastCheck Land Rover vehicles There
Page 71 and 72:
FastCheck NOTE: Services which have
Page 73 and 74:
FastCheck Variable Service Reset (V
Page 75 and 76:
FastCheck Citroen, Peugeot, Fiat an
Page 77 and 78:
FastCheck Renault (Type 2) With the
Page 79 and 80:
FastCheck • Drive off. The Reset
Page 81 and 82:
FastCheck OM1346 • The Warning La
Page 83 and 84:
Manufacturer Applications Audi, Sea
Page 85 and 86:
Manufacturer Applications Adding tr
Page 87 and 88:
Manufacturer Applications Engine Co
Page 89 and 90:
Manufacturer Applications Table 1 -
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Manufacturer Applications 11 1. Eng
Page 99 and 100:
Manufacturer Applications 5 1. Engi
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Manufacturer Applications 7 1. Idli
Page 109 and 110:
Manufacturer Applications 7 1. Lamb
Page 111 and 112:
Manufacturer Applications 19 1. Eng
Page 113 and 114:
Manufacturer Applications Table 15
Page 115 and 116:
Manufacturer Applications NOTE 1: L
Page 117 and 118:
Page 119 and 120:
Manufacturer Applications 13 1. Ign
Page 121 and 122:
Manufacturer Applications NOTE: Tot
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Manufacturer Applications 15 1. Kno
Page 137 and 138:
Page 139 and 140:
Manufacturer Applications Table 26-
Page 141 and 142:
Manufacturer Applications Table 27-
Page 143 and 144:
Manufacturer Applications NOTE: A l
Page 145 and 146:
Manufacturer Applications 25 System
Page 147 and 148:
Page 149 and 150:
Manufacturer Applications 21 Lambda
Page 151 and 152:
Manufacturer Applications 3 EGR Sys
Page 153 and 154:
Page 155 and 156:
Manufacturer Applications 4 Injecti
Page 157 and 158:
Page 159 and 160:
Manufacturer Applications 2 Idling
Page 161 and 162:
Page 163 and 164:
Manufacturer Applications 7 Tempera
Page 165 and 166:
Page 167 and 168:
Manufacturer Applications NOTE: The
Page 169 and 170:
Page 171 and 172:
Page 173 and 174:
Page 175 and 176:
Page 177 and 178:
Page 179 and 180:
Page 181 and 182:
Manufacturer Applications 56 Idle S
Page 183 and 184:
Page 185 and 186:
Manufacturer Applications 16 Knock
Page 187 and 188:
Page 189 and 190: Manufacturer Applications 2 1. Engi
Page 191 and 192: Manufacturer Applications Table 83
Page 193 and 194: Manufacturer Applications Basic Set
Page 195 and 196: Manufacturer Applications Re-coding
Page 197 and 198: Manufacturer Applications Variable
Page 199 and 200: Manufacturer Applications BMW NOTE:
Page 201 and 202: Manufacturer Applications Regenerat
Page 203 and 204: Manufacturer Applications A fault c
Page 205 and 206: Manufacturer Applications 3. Wait f
Page 207 and 208: Manufacturer Applications Inter-cha
Page 209 and 210: Manufacturer Applications Bosch M7.
Page 211 and 212: Manufacturer Applications Magneti M
Page 213 and 214: Manufacturer Applications 13. Befor
Page 215 and 216: Manufacturer Applications Fiat, Alf
Page 217 and 218: Manufacturer Applications 4. The en
Page 219 and 220: Manufacturer Applications When the
Page 221 and 222: Manufacturer Applications Self Test
Page 223 and 224: Manufacturer Applications KO ER Tes
Page 225 and 226: Manufacturer Applications OM1349 OM
Page 227 and 228: Manufacturer Applications OM1352 1.
Page 229 and 230: Manufacturer Applications OM1354 2.
Page 231 and 232: Manufacturer Applications Live Data
Page 233 and 234: Manufacturer Applications A feature
Page 235 and 236: Manufacturer Applications Clear Fau
Page 237 and 238: Manufacturer Applications to re-rea
Page 239: Manufacturer Applications Honda ALB
Page 243 and 244: Manufacturer Applications Transmitt
Page 245 and 246: Manufacturer Applications Pre-test
Page 247 and 248: Manufacturer Applications Pre-test
Page 249 and 250: Manufacturer Applications Mercedes
Page 251 and 252: Manufacturer Applications If the Om
Page 253 and 254: Manufacturer Applications 72 Pyrote
Page 255 and 256: Manufacturer Applications Renault E
Page 257 and 258: Manufacturer Applications Renault T
Page 259 and 260: Manufacturer Applications Renault (
Page 261 and 262: User Menu Tester Setup The tester s
Page 263 and 264: User Menu Security Most of the appl
Page 265 and 266: Glossary of terms Term Description
Page 267 and 268: 262 Appendix A: Glossary ESV (Drive
Page 269 and 270: MPH miles per hour MST Manifold Sur
Page 271 and 272: TVV Thermal Vacuum Valve TWC Three
Page 273 and 274: CR0231 CR0230 OG2013 - PSA 30 pin c
Page 275 and 276: CR0228 CR0235 OG2002 - BMW cable OG
Page 277 and 278: Appendix C: Diagnostic Connector Lo
Page 291 and 292:
Appendix D: Manual Service Reset Au
Page 293 and 294:
Appendix D: Manual Service Reset NO
Page 295 and 296:
Appendix D: Manual Service Reset C3
Page 297 and 298:
Appendix D: Manual Service Reset Re
Page 299 and 300:
Appendix D: Manual Service Reset Xs
Page 301 and 302:
Appendix D: Manual Service Reset Fi
Page 303 and 304:
Appendix D: Manual Service Reset GM
Page 305 and 306:
Appendix D: Manual Service Reset La
Page 307 and 308:
Appendix D: Manual Service Reset Pe
Page 309 and 310:
Appendix D: Manual Service Reset 40
Page 311 and 312:
Appendix D: Manual Service Reset Bo
Page 313 and 314:
Appendix D: Manual Service Reset Re
Page 315 and 316:
Appendix D: Manual Service Reset La
Page 317 and 318:
Appendix D: Manual Service Reset Ve
Page 319 and 320:
Appendix D: Manual Service Reset Vo
Page 321 and 322:
Page 323 and 324:
Page 325:
Omitec Hopton Industrial Estate Lon
show all

Scan Tool Operating Instructions - AK Automotive Training

Create successful ePaper yourself

Delete template?

Save as template?