Scan Tool Operating Instructions - AK Automotive Training

37
FastCheck
Pre-Test conditions:
• The vehicle must be stationary
• The vehicle must be on level ground
• The vehicle must be secured with wheel locks
This function takes 35 seconds to complete.
This function also automatically performs an 'Assembly Check', which carries out
internal tests on the Parking Brake system and reports the status (see below). Ensure
the on screen instructions on the service tool are followed precisely and in the correct
order.
Assembly Check
This function is used to check the operation of the parking brake system after any
work has been completed on the system.
Pre-Test conditions:
• The vehicle must be stationary
• The vehicle must be on level ground
• The vehicle must be secured with wheel locks
This function takes 25 seconds to complete.
NOTE: This test is automatically run as part of the 'Exit Maintenance Mode' function.
It is not necessary to perform this function if the 'Exit Maintenance Mode' function
reported no problems
NOTE: This function can not be performed while the parking brake system is in
maintenance mode. It should only be performed when the system is in normal
operating mode.
Ensure the on screen instructions on the service tool are followed precisely and in the
correct order.
Actuators
The following is available under the ‘Actuators’ menu option:
Static Apply
This function is used to test the operation of the actuators which operate the calipers.
This function closes the actuators to the nominal parking brake apply position.