Scan Tool Operating Instructions - AK Automotive Training

54 Idle Speed
Switch
Manufacturer Applications
1. Engine speed.
2. Engine operating condition (idle, part load, etc.).
3. Throttle valve angle.
4. Throttle valve positioner angle.
56 1. Engine speed.
2. Specified engine speed.
3. Intake air mass.
4. Operating conditions (for the relevance of this display line, see
Table 83).
90 Camshaft
Timing
Control
93 Hall
Senders
95 Intake
Manifold
Change-over
1. Engine speed.
2. Camshaft timing control status.
3. Feedback signal for adjustment - bank 1.
4. Feedback signal for adjustment - bank 2.
1. Engine speed.
2. Engine load.
3. Phase position - bank 1.
4. Phase position - bank 2.
1. Engine speed.
2. Engine load.
3. Engine coolant temperature.
4. Intake manifold change-over status (see note below).
NOTE: Intake manifold change-over should occur at approximately 4500 rpm.
98 Throttle
Control part
adaption
122 Torque
Reduction
during
Gearshift
1. Throttle valve angle sensor voltage.
2. Idle speed positioner voltage.
3. Engine operating status (idle, part load, etc.).
4. Adaption status.
1. Engine speed.
2. Specified gearbox torque.
3. Engine torque.
4. Ignition timing reduction status.
185