Scan Tool Operating Instructions - AK Automotive Training

Correct Option:
59
FastCheck
The Correct option is used to correct a service option which has been reset in error.
NOTE: Reset correction is only available for service options with service counter not
zero, and is not available for vehicle and exhaust emission inspections. The original
service option values are lost during reset.
Use the and keys to change the reset value.
Use the key to complete the information entry.
A final confirmation of the new data entered is displayed. Press the key to store the
new information. To cancel the correction and return to the service option list press
the key.
NOTE: The maximum reset value will be the current value of the selected service
option. The service counter will be decremented by 1.
Digital Reset:
Select Digital Reset for vehicles only fitted with a J1962 16 pin connector and do not
support Condition Based Service (CBS).
The OmiCheck will display a message to confirm the reset process was successful.
Applicable vehicles:
BMW 3 Series (E46)
BMW 5 Series (E39)
BMW 7 Series (E38)
BMW X3 (E83)
BMW X5 (E53)
BMW Z4 (E85)
NOTE: A manual procedure for service reset is possible for some Digital Reset
applicable vehicles. Refer to Manual Service Reset section for instructions.
Analogue Reset:
Select Analogue Reset for vehicles fitted with a 20 pin round diagnostic connector
within the engine bay.
The OmiCheck will display the message “Reset complete” to confirm the reset
process was completed.
NOTE: The OmiCheck indicates the completion of the process only. Visual
confirmation via the Service Interval Indicator (SIA) located on the vehicle’s dash
panel is required.