Scan Tool Operating Instructions - AK Automotive Training

FastCheck
Replace Pads
Select the Replace Pads option from the Replace Pads menu. The brake pistons will
now be moved to their released position. Wait until the OmiCheck displays the
release brakes now open for pad change message before continuing.
Replace the Brake Pads
The brake pads can now be replaced following the manufacturer’s instructions.
Pad Thickness
The brake pad thickness must be now be entered by selecting Pad Thickness from
the Replace Pads menu. The current value is displayed on screen. Press the key
to change value then enter the new value between 3-14mm. Press the key to test
the new value a message will be displayed. Press the key to move to the store new
value screen. Now press the key again to store the new value to the control
module.
Close Brakes
Select the Close Brakes option from the Replace Pads menu. The brake pistons will
now be moved to their reset position. Wait until the OmiCheck displays the close
brakes now complete message before continuing.
Calibrate Brakes
Select the Calibrate Brakes option from the Replace Pads menu. The brake pistons
will now be moved in and out to calibrate their position. Wait until the OmiCheck
displays the calibrate brakes now complete massage before continuing.
Brakes Service Sequence (Only)
The EPB system must be deactivated and completely released and the ignition must
be on then follow the sequence described below.
NOTE: The sequence must be performed in the correct order else the braking system
maybe left in a non-operational state.
Release Brakes
Select the Release Brakes option from the Service Brakes menu. The brake pistons
will now be moved to their released position. Wait until the OmiCheck displays the
release brakes now complete message before continuing.
Service the Brakes
The brakes can now be serviced following the manufacturer’s instructions.
46