Training, Installation & Service Manual - Livewire Connections Ltd

Configuration with the web interface
6.3.9.4 Line up and commissioning
The SAILOR 900 VSAT antenna systems must be lined up and
commissioned one by one. The lineup procedure is done for each
antenna as it would have been done for a single antenna system. In
order to be able to do the lineup for each antenna you must force
the dual system to use one or the other antenna at a time. Do as
follows:
1. Enter the web interface of the Master ACU, go to the page
SERVICE > Dual antenna mode.
2. Set the mode to either Master active or Slave active to force the
system to use that antenna until it is changed again or the Master
system is rebooted. After reboot the dual antenna mode will be
set to Auto (default).
6.3.10 Upload
Figure 6-33: Dual-antenna mode, line up
For uploading new software to the SAILOR 900 VSAT see Software
update on page 9-5.
6-42 Chapter 6: Configuration 98-133966-E2