Training, Installation & Service Manual - Livewire Connections Ltd

Configuration 6
This chapter is organised in the following sections:
• Introduction to the built-in web interface
• Calibration of the SAILOR 900 VSAT
• Configuration with the web interface
• Keypad and menus of the ACU
• SNMP support
Chapter 66666
6.1 Introduction to the built-in web
interface
6.1.1 Overview
Use the built-in web interface of the SAILOR 900 VSAT ACU to make
a full configuration of the SAILOR 900 VSAT with the correct VMU,
the satellite positions you intend to use and other parameters.
Configuration
Figure 6-1: Configuration setup
For the rack version, connect the LAN cable to the front LAN
connector of the ACU.
For quick start instructions see Calibration of the SAILOR 900 VSAT
on page 6-4.
Note
For information on daily use of the SAILOR 900 VSAT system
refer to the SAILOR 900 VSAT Quick Guide or see chapter 8,
Daily use — Quick guide.
98-133966-E2 6-1