Training, Installation & Service Manual - Livewire Connections Ltd

F.8 RF interference
Interference induced from nearby high-power RF transmitters might
cause system failures and in extreme cases permanent damage to
the SAILOR 900 VSAT equipment. If there are problems with
interference from HF transmitters, it is advisable to mount ferrite
clamps on the coax cable in order to provide suppression of induced
RF. The ferrites will have no effect on the differential-mode signals
but increases the impedance in relation to common-mode RFI.
F.8.1
Recommendations
Use 1-5 pcs. hinged clamp cores (e.g. the RFC or SFC series from
Kitagawa) mounted on the ADU cable near the ADU.
RF interference
FFFF
Grounding and RF
98-133966-E2 Chapter F: Grounding and RF protection F-15