Training, Installation & Service Manual - Livewire Connections Ltd

Supported commands
Command
system restart
system info
Description
Sends a command to the ACU to restart the system
instantaneously. It makes a power-on self test and then
points to the last used satellite.
Shows the software version, part names and serial
numbers of the SAILOR 900 VSAT.
Table D-10: UCLI command: system
D.2.10 track
Command
track
track mode
track mode dvb
track dvb_sym
track dvb_sym 22
track dvb_nid
track dvb_nid 0
Description
Shows the sub commands available, including a short
description.
Shows or sets the receiver bandwidth or mode, the way
the SAILOR 900 VSAT tracks the satellite:
• narrow (recommended, uses the built-in 300 kHz
filter of the SAILOR 900 VSAT)
• rssi (uses the RSSI signal from the VSAT modem)
• wide (uses the wide-band filter to track the satellite)
• dvb (uses the built-in DVB-S2 receiver of the SAILOR
900 VSAT to track the satellite. You must configure
dvb_sym and dvb_nid.)
Shows or sets the current mega symbols rate for the
DVB-S2 receiver when in dvb mode. The symbol rate
used to verify and track a transponder.
• Valid range: 0.1 — 99
Shows or sets the DVB NID to be verified by the built-in
DVB-S2 tracking receiver, when using tracking mode
DVB. It configures the NID used to verify and track a
transponder.
• Valid range: 0 — 65535
A NID of ‘0’ disables the NID check. Then the NID
will be omitted in the verification of the transponder.
Table D-11: UCLI command: track
D-10 Appendix D: Command line interface 98-133966-E2