Training, Installation & Service Manual - Livewire Connections Ltd

Introduction to the built-in web interface
No installation of software is necessary. The web interface is built
into the SAILOR 900 VSAT ACU.
You access the web interface from a computer with a standard
Internet browser.
6.1.2 Connecting to the web interface
To connect to the web interface of the ACU do as follows:
1. Power up the SAILOR 900 VSAT system, i.e. switch on the ACU.
Wait until the LEDs on the front plate of the ACU show that the
system is ready to be configured.
• Power LED: Green
• Logon LED: Off
• Fail/Pass LED: Flashing green, during power-on self test, after
that steady green.
2. Connect a PC to LAN interface 3 (Service port, standard Ethernet)
of the ACU. For the rack version connect the LAN cable or to the
front LAN connector of the ACU.
Figure 6-2: LAN connector used for configuring the SAILOR 900 VSAT
3. Open your Internet browser and enter the IP address of the ACU.
The IP address is http://192.168.0.1 (default).
4. The web interface opens directly with the DASHBOARD page.
6-2 Chapter 6: Configuration 98-133966-E2