Training, Installation & Service Manual - Livewire Connections Ltd

More documents

Recommendations

Info

Technical specifications A.1 SAILOR 900 VSAT system components A Appendix A AAAA Technical specifications A.1.1 General specifications Item Specification Frequency band Rx Tx Reflector size Ku-band (VSAT) 10.70 to 12.75 GHz 13.75 to 14.50 GHz (extended) 103 cm (40 inch) Certification (approval) Compliant with CE (Maritime), ETSI EN 302 340, CEI/IEC 60950-1, CEI/IEC 60945, CEI/IEC 60950-22 ADU cable type (ACU to ADU) ADU cable connector at the ADU ADU cable connector at the ACU System power supply range Total system power consumption Single 50 Ohm coax cable for Rx, Tx, ACU-ADU modem and power Female N-Connector (50 Ohm) Female N-Connector (50 Ohm) 20—32 VDC (Start up voltage: 22 VDC guaranteed) 370 W peak, 175 W typical (up to 8 W BUC) Table A-1: General specifications 98-133966-E2 A-1
Page 1:
TRAINING, INSTALLATION & SERVICE MA
Page 4 and 5:
Disclaimer Any responsibility or li
Page 6 and 7:
Compass Safe Distance: SAILOR 900 V
Page 8 and 9:
vi 98-133966-E2
Page 10 and 11:
Table of contents Chapter 3 Install
Page 12 and 13:
Table of contents 6.2 Calibration o
Page 14 and 15:
Table of contents Appendix A Append
Page 16 and 17:
Table of contents F.4 Alternative g
Page 18 and 19:
List of figures Figure 3-22: ADU, b
Page 20 and 21:
List of figures Chapter 7 Installat
Page 22 and 23:
List of figures Figure 9-68: Polari
Page 24 and 25:
List of figures Figure C-5: Satelli
Page 26 and 27:
List of tables Table 6-3: Possible
Page 28 and 29:
List of tables xxvi 98-133966-E2
Page 30 and 31:
Software version 1.3 Software versi
Page 32 and 33:
Precautions 1-4 Chapter 1: About th
Page 34 and 35:
SAILOR 900 VSAT system The followin
Page 36 and 37:
SAILOR 900 VSAT system 2.1.2 Above
Page 38 and 39:
SAILOR 900 VSAT system 9. Polarisat
Page 40 and 41:
SAILOR 900 VSAT system 2.1.3 Antenn
Page 42 and 43:
SAILOR 900 VSAT system 2.1.3.3 Serv
Page 44 and 45:
Part numbers and options 2-12 Chapt
Page 46 and 47:
Unpacking 3.1.1.3 ACU (19” rack v
Page 48 and 49:
Site preparation 3.2.2 Obstructions
Page 50 and 51:
Site preparation zones (RX and TX)
Page 52 and 53:
Site preparation 3.2.6 ADU mast des
Page 54 and 55:
Site preparation 3.2.6.2 Mast lengt
Page 56 and 57:
Site preparation Mast with 2 braces
Page 58 and 59:
Site preparation Radar Min. 15° Mi
Page 60 and 61:
Site preparation 3.2.7.4 GPS receiv
Page 62 and 63:
Installation of the ADU 3.3 Install
Page 64 and 65:
Installation of the ADU 4. Attach a
Page 66 and 67:
Installation of the ADU Otherwise,
Page 68 and 69:
Installation of the ADU Figure 3-22
Page 70 and 71:
Installation of the ACU (bulkhead)
Page 72 and 73:
Installation of the ACU (bulkhead)
Page 74 and 75:
Installation of the 19” rack vers
Page 76 and 77:
Installation of the VMU 3.6 Install
Page 78 and 79:
Installing the dual-antenna mode (o
Page 80 and 81:
Interfaces of the SAILOR 900 VSAT A
Page 82 and 83:
Page 84 and 85:
Page 86 and 87:
Page 88 and 89:
Interfaces of the VMU 4.2.2 Connect
Page 90 and 91:
Interfaces of the VMU 4.2.5 Connect
Page 92 and 93:
Power cable selection 5.2 Power cab
Page 94 and 95:
Connecting power For other cable ty
Page 96 and 97:
Power up 5.4.0.1 Initialisation in
Page 98 and 99:
Introduction to the built-in web in
Page 100 and 101:
Calibration of the SAILOR 900 VSAT
Page 102 and 103:
Page 104 and 105:
Page 106 and 107:
Page 108 and 109:
Page 110 and 111:
Configuration with the web interfac
Page 112 and 113:
Page 114 and 115:
Page 116 and 117:
Page 118 and 119:
Page 120 and 121:
Page 122 and 123:
Page 124 and 125:
Page 126 and 127:
Page 128 and 129:
Page 130 and 131:
Page 132 and 133:
Page 134 and 135:
Page 136 and 137:
Page 138 and 139:
Page 140 and 141:
Page 142 and 143:
Page 144 and 145:
Page 146 and 147:
Keypad and menus of the ACU After 1
Page 148 and 149:
Keypad and menus of the ACU 6.4.3.1
Page 150 and 151:
Keypad and menus of the ACU SATELLI
Page 152 and 153:
SNMP support 6-56 Chapter 6: Config
Page 154 and 155:
Installation check list: Antenna St
Page 156 and 157:
Installation check list: ACU, conne
Page 158 and 159:
Installation check list: Functional
Page 160 and 161:
SAILOR 900 VSAT Viewing system para
Page 162 and 163:
Getting support: Helpdesk 9.1 Getti
Page 164 and 165:
Getting support: Helpdesk 9.1.1.4 S
Page 166 and 167:
Software update Note that the uploa
Page 168 and 169:
Status signalling with LEDs and sta
Page 170 and 171:
Status signalling with LEDs and sta
Page 172 and 173:
Removal and replacement of ADU modu
Page 174 and 175:
Page 176 and 177:
Page 178 and 179:
Page 180 and 181:
Page 182 and 183:
Page 184 and 185:
Page 186 and 187:
Page 188 and 189:
Page 190 and 191:
Page 192 and 193:
Page 194 and 195:
Page 196 and 197:
Page 198 and 199:
Page 200 and 201:
Page 202 and 203:
Page 204 and 205:
Page 206 and 207: Removal and replacement of ADU modu
Page 250 and 251: Updating VIM/PCM calibration data F
Page 252 and 253: Troubleshooting 9.7.4 Troubleshooti
Page 255: Appendices
Page 259 and 260: SAILOR 900 VSAT system components A
Page 261 and 262: SAILOR 900 VSAT system components A
Page 263 and 264: A.2.2 ACU, bulkhead Outline drawing
Page 265 and 266: A.2.4 N-connector interface on the
Page 267 and 268: A.3.1.1 Example configuration for a
Page 269 and 270: VMU cable specifications B This app
Page 271 and 272: B.2 Modem Cable iNIFINITI iDirect V
Page 273 and 274: VMU settings requirements C In this
Page 275 and 276: details on cable connections and pi
Page 277 and 278: Messages sent from the ACU to the V
Page 279 and 280: The option file must use following
Page 281 and 282: C.2 Non-Open-AMIP setup for iDirect
Page 283 and 284: C.2.2.2 Supported commands After lo
Page 285 and 286: Non-Open-AMIP setup for iDirect iNF
Page 287 and 288: C.4 STM SatLink 2900 VSAT modem C.4
Page 289 and 290: C.5 Gilat SkyEdge II VSAT modem C.5
Page 291 and 292: Command line interface D D.1 Introd
Page 293 and 294: D.1.3 Conventions The command descr
Page 295 and 296: Supported commands Command Descript
Page 297 and 298: Command satellite skew satellite sk
Page 299 and 300: Command satellite tx_if_freq satell
Page 301 and 302: Command track rx_rf_freq Command zo
Page 303 and 304: DVB-S satellites E This appendix co
Page 305 and 306: Grounding and RF protection F F.1 W
Page 307 and 308:
grounded and mount a grounding kit
Page 309 and 310:
F.3 Alternative grounding for steel
Page 311 and 312:
F.4 Alternative grounding for alumi
Page 313 and 314:
F.5 Alternative grounding for fibre
Page 315 and 316:
F.6 Separate ground cable F.6.1 Gro
Page 317 and 318:
Remember to seal the joint with pro
Page 319 and 320:
F.8 RF interference Interference in
Page 321 and 322:
System messages G G.1 Event message
Page 323 and 324:
Error code (ID) Unit Severity Descr
Page 325 and 326:
Page 327 and 328:
Page 329 and 330:
G.3 List of ACU events Error code (
Page 331 and 332:
Error code (ID) ACU PCB Severity De
Page 333 and 334:
Approvals H H.1 Satellite approvals
Page 335 and 336:
Glossary Glossary 9 A ABS ACU ADM A
Page 337 and 338:
M MIB N NID NMEA O OMT openAMIP ORE
Page 339 and 340:
Index 10 Numerics 10 MHz reference,
Page 341 and 342:
connector ADU, 4-4 DC, 4-3 DC Input
Page 343 and 344:
LED ACU, 9-8 license software, -ii
Page 345 and 346:
S safety summary, -iii samples stat
Page 348:
98-133966-E info@thrane.com • thr
show all

Training, Installation & Service Manual - Livewire Connections Ltd

Create successful ePaper yourself

Delete template?

Save as template?