Training, Installation & Service Manual - Livewire Connections Ltd

5.4 Power up
1. Connect power to the VMU.
2. Switch on the ACU. The unit starts up and goes through an
initialization procedure:
• ACU POST
• ADU Initializing
• ADU POST
• READY
This may take some time (up to a couple of minutes).
3. The SAILOR 900 VSAT is ready to be calibrated (for first time
power up) or receive data from the VSAT modem (when in normal
operation). The ACU display shows the following message:
Steady
green
Power up
5555
Figure 5-3: ACU display after first power on (example with LAN ports 1 and 4 used)
The LEDs Power and Fail/Pass are steady green, the LED Logon
is off. For further information on status indicators see Status
signalling with LEDs and status messages on page 9-8.
Make sure there are no hardware failures or error codes present,
check the display of the ACU for events. For more information on
error codes and events see Troubleshooting on page 9-91 and
System messages on page G-1.
4. Continue to get the SAILOR 900 VSAT system operational, do the
following:
• Make a cable loss and an azimuth calibration.
• Create VSAT modem profiles.
• Create one or more satellite profiles.
For step-by-step instructions, see Introduction to the built-in web
interface on page 6-1.
For installation check lists see, Installation check on page 7-1.
Connecting power
98-133966-E2 Chapter 5: Connecting power 5-5