Training, Installation & Service Manual - Livewire Connections Ltd

7.3 Installation check list: Functional
test in harbor
Step Task Further information Done
1. Check that the antenna is
tracking the satellite
2 Check that the VMU is in lock
and ready for Tx.
3 Connect a user PC LAN (not
the service PC) to the
Internet LAN connector,
either on the LAN port 2 of
the ACU (only X5 VSAT
modem) or to the User LAN
connector on the VMU.
2. Open a DOS window and
type: ping 4.2.2.2.
3. Open a web browser and
browse to www.google.com.
4. If step 4 is successful and
step 5 is not then it seems
like the DNS is not
configured correctly.
The logon LED in the ACU display
must be steady green and the
display shows: TRACKING.
In the web interface check:
DASHBOARD:
System status: Tracking
In the web interface check:
DASHBOARD > VSAT MODEM >
Signal level and RX frequency
show values.
Check the VSAT modem
documentation for details.
Check that you get a response.
Check that the web page is
downloaded.
Check with the VSAT modem
documentation how the DNS server
must be set up, “Obtain DNS server
address automatically” or enter
specific DNS server addresses.
Table 7-3: Installation check list: Functional test in harbour
Installation check list: Functional test in harbor
7777
Installation check
98-133966-E2 Chapter 7: Installation check 7-5