Training, Installation & Service Manual - Livewire Connections Ltd

9.2 Software update
9.2.1 Hardware and software requirements
The following items are required before the software can be
updated:
• One computer with a standard Ethernet port available.
• A standard Internet browser.
• 1024×768 pixels or higher display resolution. The program is best
viewed using small fonts.
• One straight LAN cable.
• The file containing the new software.
9.2.2 Software update (ADU and ACU)
Note
1. Power up the SAILOR 900 VSAT system, i.e. switch on the ACU.
Wait until the SAILOR logo has disappeared from the ACU display.
2. Connect a PC to LAN interface 3 (Service port, standard Ethernet)
of the ACU. For the rack version, connect the LAN cable to the
front LAN connector of the ACU.
3. Open your Internet browser and enter the IP address of the ACU.
The IP address is http://192.168.0.1 (default). For further details
on network setup see Configuring the LAN network on page 6-29.
4. The web interface opens directly with the DASHBOARD page.
5. Click SERVICE from the left navigation pane. The Upload page is
displayed.
6. Click Browse... and locate the new software file.
7. Click Upload.
Software update should only be done by qualified service
personnel.
Figure 9-3: LAN connector used for configuring the SAILOR 900 VSAT
Software update
9999
Service & maintenance
98-133966-E2 Chapter 9: Service & maintenance 9-5