Training, Installation & Service Manual - Livewire Connections Ltd

6.4.5 Resetting the system
To reset the system do the following:
1. Press and hold and until the ACU display shuts down and
the ACU reboots.
2. Wait until the system has rebooted and is operational again. The
last active satellite profile will be used.
6.5 SNMP support
The SAILOR 900 VSAT supports SNMP v2 requests to retrieve
configuration and present settings. SNMP is always enabled on all
Ethernet interfaces. The SNMP community string is public.
The SAILOR 900 VSAT offers via SNMP most of the data that are
available from the DASHBOARD web pages. Detailed documentation
about supported OIDs can be found in the SAILOR 900 VSAT MIB
file.
The MIB entries are grouped as shown below:
• System configuration
• Navigation coordinates
• Antenna pointing
• Dashboard and profile
• Tracking receiver
Note
Figure 6-42: Reset the system
All SNMP values are of a nature which does not need to be
polled more often than once a minute. Polling SNMP values
more frequently will impact the performance of the ACU.
SNMP support
6666
Configuration
98-133966-E2 Chapter 6: Configuration 6-55