Training, Installation & Service Manual - Livewire Connections Ltd

Installation check 7
Now that you have installed the system, you can test it to verify it is
ready for customer delivery. Follow the check lists below to test the
system for proper operation.
Chapter 77777
• Installation check list: Antenna
• Installation check list: ACU, connectors and wiring
• Installation check list: Functional test in harbor
7.1 Installation check list: Antenna
Step Task Further information Done
1. Check that the antenna is free
of obstructions.
2. Make sure there is sufficient
space for access through the
service hatch.
See Obstructions (ADU
shadowing) on page 3-4.
See Installing the ADU on
page 3-19.
3. Make sure to maintain the
vertical orientation of the ADU
center line.
4. Check that the ADU is installed
where vibrations are limited to
a minimum.
5. Check that you programmed
the blocking zones correctly.
See Blocking zones —
azimuth and elevation on
page 3-5
and
Installation check
6. Make sure that the safety distance
for radiation hazard of 30 metres
is kept.
Setting up Blocking zones
(RX and TX) on page 6-27
See Safe access to the ADU:
Radiation hazard on page 3-6
Table 7-1: Installation check list: Antenna
98-133966-E2 7-1