Training, Installation & Service Manual - Livewire Connections Ltd

Non-Open-AMIP setup for iDirect iNFINITI 5000 & Evolution X5
Section in
option file
GPS
Rx 10 MHz
Tx 10 MHz
Description
The iDirect modem must be set to mobile unit and
receive the GPS information from the ACU with the
command “latlong ”.
Tx handshake must be disabled in the iDirect modem.
The SAILOR 900 VSAT can work either using the Rx
or Tx 10 MHz reference signals provided by the
modem or using its own built-in 10 MHz reference
signal. It is recommended to use the Tx 10 MHz
reference signal from the modem. See also VSAT
modem profile — New entry and Edit on page 6-24.
The SAILOR 900 VSAT needs the Tx 10 MHz reference
signal in order to allow TX ON.
Table C-5: Requirements for VSAT modem option file, Non-OpenAMIP
C.2.3
Configuration examples (Non-OpenAMIP)
Examples of modem profile and satellite configuration from the ACU
web MMI are shown in the figures below.
Figure C-9: VSAT modem profile, Non-OpenAMIP (example)
C-12 Appendix C: VMU settings requirements 98-133966-E2